I purchased one of these kits in 2016. Seems so long ago. I just broke my pin switch that came with the kit, which is seen in the picture. I broke the plastic which turns the light off when the hood is closed. Can anyone help me in finding a replacement switch? Thanks!
Can someone help me locate or tell me what size Hose 36112D is in the below diagram? I am told it is discontinued by Toyota. An ID and OD of the tube and length would be helpful. Thanks!
HOSE, NO. 3 (FOR TRANSFER REAR CASE)
Part Number: 9044508277...
I have been hunting down two interior squeaks which it seems like forever. Tore apart the dash because it seemed like it was from there. Greased all the portions of the sun roof, thinking it was from there. These did nothing.
I decided to pull the visors out and noticed there was some foam...
Mine did the same thing after the thermocure. That thermocure smells like rotten eggs. I believe they recommend flushing the system four or five times to clear out all of the thermocure. Will foam with it in there, at least that has been my experience. Flush it a few more times and it will...
I recently installed the Hudd Expo Switch Fog Lamp Switch - fits Toyota
This was installed using a SLEE light harness and jumper harness.
The switch is wired to a fuse with a "tap a fuse" adapter to run the illumination. I chose the 15 Amp rear light fuse in the panel by the left knee in the...
If you look beyond the first paperclip cooler, (it is kind of difficult to see in the picture), the entire tube is covered in what I guess is power steering fluid? I will try to get another picture, but it is the tube that is the closest to the frame. Could the power steering cooler be rusted...
I have a leak that has developed over the last few days. There is gear oil that is leaking from the right rear hub. It is spinning oil all around the wheel and inside the wheel well. Is this likely a seal that needs replaced? Also, if it is, are there any how to's on performing this...
Forget my last post! Found multiple threads on this problem and answers to my questions. Still don't know about the copper/coolant question though? Thanks again for the help!!
Thanks again. There are always so many people here willing to help!
Glad to hear I should be able to make these. Does anyone know the tubing size? Also, will copper somehow react with the coolant? Was going to go the copper route, since it should be relatively easy to make, or would it be...
This is a photo taken looking towards the front of the LC on the passenger side. These pipes were behind a couple of heat shields above the exhaust and are essentially under the passenger seat. I decided to remove the heat shields and see what was leaking. The fluid they are leaking doesn't...
Is there a way to "pop out" the connector for the O2 Sensor to allow me to solder these back together? My O2 sensor is broken on the vehicle side at the connector and my check engine light is on. Should I just get a used connector with some wire and just solder them all together? Thanks.
GC
Thanks again everyone. I really appreciate the help. I think I have an Eaton fan clutch, so even if I could have salvaged the nuts, I doubt they would have worked with the Aisin. Going to order some nuts. So much for getting the LC fixed tomorrow!
Does the Aisin fan clutch from Amazon come with nuts? Removed my old fan clutch and destroyed the nuts. If it doesn't should I just get some nuts and lock washers at Lowes? Or anyone have a part number for the nuts. Thanks.
GC