I did the following:
1. KILMAT 80 mil (Covered floor, doors, roof)
2. Noico Liner Closed Cell Foam (Helps with sound, insulation and dampening)
3. Design Engineering 050113 Under Carpet Lite (Used as a jute carpet replacement helps with sound, insulation and dampening)
4. Factory carpet...
I popped out my turn signals to give them a nice polish and found a set of wires that were cut and attached to the righ turn signal harness connector. Any idea as to where these go?
Back from the dead!
All of my door lock actuators work except my front passenger one. I got to thinking, would it be possible to order an Aisin rear passenger door actuator and take that motor to swap into the front door actuator? Probably is the more costly fix, but I cannot solder to save my...
Hello all,
Really stupid question below please bear with me....
Just had my LX450 painted, and I cannot for the life of me recall how my front license plate was mounted. Do we need plastic tab inserts into the bumper then hit is with self tapping screws? Or do the screws just go in bare? Any...
I did a visual inspection of the wires from under the seat to up under the dash, nothing looked out of the ordinary. Rather than try to diagnose or fix, I do think I'll end up ripping the entire factory alarm system out to keep it simple, then if I want re-add keyless entry via aftermarket kit...
Checked the factory alarm, everything was hooked up correctly. I took a vid of it today of me holding the key to start. I also held the key over for 5 seconds, nothing, 10 seconds and nothing. Then proceeded to jump the starter solenoid straight from the battery and started right up 1st try...
I do have an RS3000 security system under my seat so I will also cross that as well. To confirm, if you elect to remove the alarm box from under the seat but leave the rest of the alarm wiring/harness in place, the truck will not start correct? Wondering if there was a quick way to delete the...
Fusible link is 2 weeks old, I have an brand new extra that I can swap in, to confirm it's working. I do see a CEL light when the key is in the ACC position, turns off when I jump the starter solenoid as the truck turns on.
My 97 LX450 only starts when I connect the starter control terminal to directly to the positive battery terminal via jumper wire. As of right now, when I turn the key to initiate the starter there is no click or crank at all. I replaced the NSS and the ignition switch and the no start/no click...