2nd that! i had auto lockers front and rear in my 60, but shortly after switched to an electric in the front. would never put an auto locker in the front again.
Can anyone tell me what way the bearing cap is suposed to go on in relation to the oil holes in the bearing. (i have checked for marking on the side of the cap and there is nothing) any help appreciated..
Thanks for you help, i have found out what the markings mean.
If your pistons are over 30 sized it will be stamped ".030"
Having a single number (like 3 or 30) stamped on each cylider indicates that it is a original set of pistons. If you have a piston with a different number than the...
I am rebuilding my 2F, After removing the head i have noticed that the pistons have "30" Stamped on the top of the piston. Does this mean that these pistons are .30 over or is that a normal marking. Do stock pistons have anything stamped on the top of them. (They are flat top pistons if that...
What do u mean by center of engine bay?? center from front to back?? or center from side to side. Im dont know for sure, but i would think it should be centered from side to side, but front to back really shouldnt make much difference.
I remember seeing an 80 series truck with 2 snorkles (passenger and drivers side). I think he made the one out of fiberglass, it turned out really well and didnt look much different than the safari.
I am looking into buying a 1988 Fj62 with a 3FE in it. The guy says that the engine is knocking really bad. I am too far away to go look at it, but what questions can i ask him to find out what the problems could be? Also what could be the possible problems? And what are the solutions if any...
Aussie lockers wont dissengage while your on the gas, others lockers are made to but aussies dont. Even in corners aussie will stay engaged as long as you are on the gas.
I have aussie lockers front and rear. I noticed a huge difference once i put them in. I use my truck as a daily driver, and it does make it difficult to drive in the winter. In the summer i leave my hub unlocked unless going off roading, but in winter i have them locked at all times. If you are...
I went to leave the house this morning and found out my truck had no brakes. I checked the fluid level and it was low, so i filled it up. I pumped the brakes and they seemed to work fine. I then took it for a ride but the brakes did not work. If i pressed the brake all the way down, my engine...