Search results for query: *

Forum search Google search

  1. Anthony Miller

    Builds Ole Blue 60 gets a fresh start- EFI and more

    Hate to see it go, always figured it was a forever keeper. Oddball is a killer replacement though.
  2. Anthony Miller

    Builds Ole Blue 60 gets a fresh start- EFI and more

    My favorite 60.
  3. Anthony Miller

    Fresh Start For A Tired 60 - 1HZ Conversion

    How did the power of the 1HZ compare to the 2f?
  4. Anthony Miller

    Builds JTUSixty - Tilda Bogue Service Station

    Maybe I missed it but can you give some info on the longblock? What rods/pistons? Head modifications? Cam specs? Compression ratio? The gains with the dyno tune, was that mostly with the timing curve? How much initial and total timing are you running? What fuel are you running? WOT target AFR?
  5. Anthony Miller

    Bilstein vs OME shocks? Part numbers?

    Would you recommend the same bilsteins for a 60 with stock bumpers and no winch?
  6. Anthony Miller

    Builds 1985 FJ60 Gets a Holley Sniper EFI Setup

    That idle AFR is pretty rich. I think mine is 14.0-14.2.
  7. Anthony Miller

    Builds Ole Blue 60 gets a fresh start- EFI and more

    I40 pole vault would have made for a cool story but I'm glad you didn't get to try it.
  8. Anthony Miller

    Mounting a fuel pump inside the fuel tank for my LS swap

    Update: Tanks Inc. sells the mounting ring and gasket now like I made so that will save you a lot of fabrication time on this project.
  9. Anthony Miller

    3F/h55f in a non usa truck: 3.70 or 4.11

    I held off on the H55F swap forever because everyone on here said a 2F wouldn’t pull 5th gear with 3.70 gears and 33’s. Well I finally bit the bullet and swapped mine last week and so far all I can say is they were absolutely wrong. The 5 speed swap is the best upgrade I’ve done other than the...
  10. Anthony Miller

    Builds Ole Blue 60 gets a fresh start- EFI and more

    You will probably have to swap master cylinders to keep the rear brakes from dragging. A residual valve is usually used with drum brakes. The valve holds roughly 10 psi in the brake lines going to the wheel cylinders. This keeps pressure against the return springs inside the drum. This means...
  11. Anthony Miller

    Fj60 om617 swap

    Any updates?
  12. Anthony Miller

    Reproduction mudflaps on ebay

    Just wondering if anybody has tried the repro mud flaps on ebay? https://www.ebay.com/itm/Toyota-Land-Cruiser-FJ60-60-FJ60-FJ62-Rear-Mud-Flaps/383836226449?hash=item595e6c0391:g:xAQAAOSwzlxfxXQx
  13. Anthony Miller

    Builds 'Brightening' a Fj60

    What are your thoughts in the 5-speed? Are you still running 3.70 gears with it? How useful is 5th gear?
  14. Anthony Miller

    "rhino liner" Paint job on my 60 price check

    Painting the outside of your LC with bed liner is WAY more expensive than paint in the long run...you’re not looking at the whole picture. say you start with a $15k FJ60...spend $5k on bedliner...now you have $20k invested in a $12k FJ60 because the bedliner REDUCED value. So that bedliner job...
  15. Anthony Miller

    Builds 'Brightening' a Fj60

    How was black bear pass? That’s been on my bucket list for a while.
  16. Anthony Miller

    3.5 Ecoboost swap...thoughts?

    I went from a 1999 Chevy C3500 dually with the Vortec 7.4L 454 engine w/4.11 gears to a 2014 F150 2wd 3.5L Ecoboost w/3.55 gears. The day I bought the F150, I pulled the exact same trailer back to back with both the C3500 dually and the F150. The trailer was an all steel 20' open car hauler...
  17. Anthony Miller

    Questions for those who have installed Holley Sniper.

    Are you running an in tank pump on that one? I think I can hear it in the video.
  18. Anthony Miller

    Questions for those who have installed Holley Sniper.

    I haven't had much time to drive it this week, probably have about 15 mins of run time since the first start. I wanted to check the cold start so I let it sit for 24hrs (in my heated shop so coolant temp was mid 70's). It started perfectly and probably a little faster than my new F150. Here's...
  19. Anthony Miller

    Questions for those who have installed Holley Sniper.

    Just to update, I got it running last night and it seems to run perfectly, I'll put some miles on it this week. I used the - side of the coil for the tach signal(yellow wire) and the 12v ignition wire(pink wire) went to the black/yellow wire in the fuel shut off connector that used to go to the...
  20. Anthony Miller

    Questions for those who have installed Holley Sniper.

    How did you mount it? Can you see it ok at a normal driving position?
Back
Top Bottom