Search results for query: *

Forum search Google search

  1. ToyotaDyna

    BJ40 Rear Turn Signal Not Working

    Do you have a cheap multimeter at hand? If not they are always good to have to test if the wire is ok Also, plug in your whole light cluster from the opposite side to test your other cluster. Here is the wiring diagram for the BJ40 from @Coolerman he is an expert on wiring for our 40's LAND...
  2. ToyotaDyna

    “Early” B motor Water pump nightmare.

    Hi, Would this one suit your 40? ------- Looking for a Diesel, LHD Land Cruiser? Canarian Land Cruiser Exports
  3. ToyotaDyna

    “Early” B motor Water pump nightmare.

  4. ToyotaDyna

    24 Volt BJ40 parasitic draw test

    Hi Guys, To carry out a parasitic draw test on a 24 volt BJ40 wired in series would I just dissconnect the earth terminal ( nearest the earth strap ) and put my multimeter between the - battery post and battery clamp like a 12v? Thanks in advance! ToyotaDyna --------- Looking for a Diesel...
  5. ToyotaDyna

    BJ40 Rear Turn Signal Not Working

    Hi, Did you try to clean off any corrosion inside the socket? It could also be a broken wire or even at the connection in the block connector. ToyotaDyna ------- Looking for a Diesel, LHD Land Cruiser? Canarian Land Cruiser Exports
  6. ToyotaDyna

    Temperature gauge for 78 BJ40 with B series 3.0 diesel

    Hey, I have a '78 BJ40 with the B motor and the guage is on about 1/4 and will raise slightly under load. Flush your coolant system every year it will help a bit also. ToyotaDyna ------ Looking for a Diesel LHD Land Cruiser? Website: www.canarianlandcruiserexports.com Instagram: Canarian...
  7. ToyotaDyna

    BJ40 B Diesel water pump install

    Thanks for your input 👍 I'm currently removing the bung from the old pump to install on the new one. The screws on the plate are marked with a marker from the Factory so I'm going to assume that it has a good seal. If not I can always just pull it back off again and seal it, not a biggie...
  8. ToyotaDyna

    BJ40 B Diesel water pump install

    Hi everyone, So I'm replacing my water pump that was making a lot of noise and leaking. The replacement has arrived finally and came with the gasket too. Its for an early B diesel motor. Do you recommend that I open the backing plate on the water pump and seal the gasket there with the high...
  9. ToyotaDyna

    BJ40 24v Alternator rebuild

    Thanks! I'm just waiting for the magnet wire to arrive and will post the pics of the process if it works out or not. ToyotaDyna ------- Looking for a LHD Diesel Land Cruiser? Canarian Land Cruiser Exports • DIESEL • LHD
  10. ToyotaDyna

    BJ40 24v Alternator rebuild

    Thanks, I have one of the newer 24 v alternators. Today I picked up a newer alternator bracket from a friend that bolts straight to my block and the narrower alternator will fit. Now I can try rewind my original and keep it as a spare. Also, when I opened mine, there was a loose connection...
  11. ToyotaDyna

    BJ40 24v Alternator rebuild

    Thanks for your reply. I left it into an auto electric shop and gave them spare brushes I had to fit. He apparently tested It too and said It was all good. When I fitted it again and turned the key to the on position and it blew the engine fuse. So I brought the whole truck back. They...
  12. ToyotaDyna

    B motor drive belt

    They have other parts also for the BJ40, I get mine from their store in Tenerife, but the main warehouse is in France. ToyotaDyna ------- Looking for a LHD, Diesel Land Cruiser? Canarian Land Cruiser Exports • DIESEL • LHD
  13. ToyotaDyna

    B motor drive belt

    Hey Corvallis, http://www.euro4x4parts.com/recambios_toyota/landcruiser_serie_40/bj40_2_9d_diesel_1974_1984/1_mantenimiento/C/correa_trapezoidal ToyotaDyna ---- Looking for a LHD, Diesel Land Cruiser? Canarian Land Cruiser Exports • DIESEL • LHD
  14. ToyotaDyna

    BJ40 24v Alternator rebuild

    Hi Guys, Would anyone know what guage copper wire is best to rewind the rotor coil in a 24v alternator? I have mine out and am going to have a go at rewinding the rotor. No one is able to rewind them here and I am having fitment issues with aftermarket alternators. Being able to keep the...
  15. ToyotaDyna

    Diagnosing issue with my clutch master cylinder

    I had the same issue with my BJ40 ( for the brake master cylinder though ) at the time I bought the rebulit kit, it only lasted a few months. For this reason I bought the whole unit, Toyota genuine cheaper version. That was 5 years ago and its hasn't given any problems yet. Now I make sure...
  16. ToyotaDyna

    Diagnosing issue with my clutch master cylinder

    Thanks roscoFJ73, I'm too used to the non Boosted clutches in the older Dynas 😂
  17. ToyotaDyna

    Diagnosing issue with my clutch master cylinder

    This should be your one. Just check your VIN and frame. https://www.toyodiy.com/parts/p_J_199210_TOYOTA_DYNA_BU73-MDPDT4_4702.html ToyotaDyna ----- Looking for a LHD, Diesel, Landcruiser? Canarian Land Cruiser Exports • DIESEL • LHD
  18. ToyotaDyna

    Diagnosing issue with my clutch master cylinder

    Hi there, It would be best to change the whole master cylinder for a new one, more than likely the bore is pitted and has torn the last seal. If you open the cylinder and just put a kit in, it will fail again in the near future. Open it up have have a look at the bore inside anyway...
  19. ToyotaDyna

    1982 BJ44 Soft Top

    Hi Jeremy, Shes a nice 40! They are great to start with and easy to work on to! It looks like its an Japanese import. ToyotaDyna ----- Looking for a rust free, LHD Land Cruiser? Canarian Land Cruiser Exports • DIESEL • LHD
  20. ToyotaDyna

    Black smoke from B engine

    Hi, If It is the diaphragm damaged or ripped the revs would increase at tick over and blue/white smoke would come out. ToyotaDyna ------- Looking for a LHD, Diesel Landcruiser? Canarian Land Cruiser Exports • DIESEL • LHD
Back
Top Bottom