Search results for query: *

Forum search Google search

  1. pb4ugo

    Cracked Transfer Case Today

    In this situation, I certainly would have determined that I'm not going to be using that case again. So, then the case is sacrificial, cause it's broke already. If I wanted the idler gear, I would either be cutting or busting the case up to get the internal parts out, or pounding the idler...
  2. pb4ugo

    Cracked Transfer Case Today

    When I was running the stk case I did not tighten the propeller frame bolts too tight, and the driver side was a little loser. I also had the engine mounts tight. I've worked on a lot of CJ's & YJ's and found j**p used a torque arm extending towards the driverside with their transfer case...
  3. pb4ugo

    Cracked Transfer Case Today

    The 40 with the nv4500 has the stk 75's tcase and has the propeller. It probably looks just like yours except 8" further back in the frame. The po had it installed. Nv4500's are long. I plan on getting a tcase saver and call it done for now. I still have my collection of tcases. The...
  4. pb4ugo

    Cracked Transfer Case Today

    The OP already has a V8, so he has to deal with what he has. He either has to replace the 1 piece tcase and I'd ad a tcase saver and drive a little conservative or come up with a different setup. Dumping the clutch, burnouts on blktop, or jerking the driveline can break the case or the...
  5. pb4ugo

    Cracked Transfer Case Today

    I don't believe the crossmember is the reason for the case cracking. It's the offset rear output t/case and putting all the power thru an idler shaft and gear which is installed in an aluminum case. Actually it's not because the case is aluminum, it's more the design of the case. I've...
Back
Top Bottom