Need an front upper shock bolt with bolts and washers for a 71 fj40 shipped to Nor Cal. Haven't been checking in here often, so please e-mail me at alex.j.t@sbcglobal.net. Need asap.
What is the factory angular relationship between castor and pinion angle. I recently did a soa on my cruiser and set my pinion angle to 0*. I needed to keep it at zero, because I am running a Downey 1" thick adapter from th350 to 3sp tcase and do not have the clearance for a cv joint. I am...
Have a receiver hitch from an fj60 that I parted. Has the bolts. I'll take $100 + shipping. Located in Chico, Ca.
http://i1128.photobucket.com/albums/m491/alex_j_t/73efbeb896af165319b72c3e2e6da809_zps4f1302ca.jpg
I need to put an fj60 cv on rear of my 3sp t-case. If i did my homework, the 74-78 should be course spline, large pattern and fit my needs. I am located in nor cal.
I am parting out a 1986 fj60. Will be listing parts on eBay under alex_71lc but will sell directly as well. I want to keep positive cruiser karma, so send me requests WITH A REASONABLE OFFER and I will see if I have it. Axles, steering, mc and booster, and basic engine are not for sale at this...
I can not get the inner axles out of the housing. It was a recently purchased disk brake front end out of a 78 FJ40 with an ARB. Have the knuckles stripped off. While removing the passenger side shaft, the birf came right off leaving the inner axle in place. No sign of the snap ring. I have...
I have been holding on parts left over from a 4wl disk swap but need space in the garage. Free drum brake parts from backing plates/knuckles out. If you want the parts you need to take them all. I hate tossing parts, but if no one needs/wants them, i guess the parts are off to the scrapper...
I am using the 1" downey kit to adapt a th350 to an LC t-case. Downey had a front yoke kit that clears the tranny pan. Apparently I waited too long to order the kit (I just found out they went out of business). Any ideas?
I am looking to borrow the knuckle centering SST. I am located in Chico, CA. Need to know your terms and how long you can part with it. I have a 4 month old and I'm finding harder to get out into the shop.