1978 - fj40 - $22,000 -
Time to sell this rig, I have had it a few years and lots of new parts from a couple of old 1977's
It just kind of sits as I don't have time for it.
Pretty good shape, aqualu tub. so rust is never an issue -
needs some new exhaust hagers and window channels, but drive...
For 2014 Tacoma—or 2nd gen - After a couple of major camp outs and time spent traveling in It . I have to seek to sell my ripcord camper
$3000.00
These are not factory but home build items
will stay dry in the camper part but could use new side doors
See the ripcord threads in tacoma world...
1978 fj40!stock carb
It seems like while decelerating and in gear. I get some torque to the wheels as if the intake is still getting gas the car stutters and feels like tourque moving the fj40 forward
And
I can start from second gear and not give it gas…,
So I’m thinking carb issue but gas...
1978 fj40
Well….. stumped ….
When the fj40 is in gear and driving under load I get a strange wobble or almost a stutter in the engine .., grabbing clutch or grabbing brakes
But
Once in neutral it goes away…
Fluids are topped off, engine timed. New spark plugs, does it in 2wd and 4WD...
Diagnosing some vibrations …
What might others have for front drive shaft rotational free play.
In RWd only it seems to rotate 20-40 degrees
In 4WD low and high it is solid
Thanks
Ok. Stripped my oil outlet on my transfer case
I got it sealed up with grey gasket stuff but this is temp
Might anyone know if this can be tapped It looks like 24 mm. But maybe that is too big??
Or just seal the hole permanently and use a pump to suck it out. When needed
Any ideas to...
SELLING My 1977 parts rig...
See images
dont have time to part out and I dont need much else..
body is toast, firewall, aprons, hood are decent - doors need bottoms cut off, have fj40 front heater and carb in a box somewhere in the gayrage as well s SPEEDOCLUSTER
email for questions
Rebuilding my solid transfer case 1978 4 speed
upon reassembly of the high and low gear and the front cone I seem to still have 1/8” of in and out play on rear drive shaft. This doesn’t seem right..,
will this play be removed with the installation of the rear housing and or perhaps a bearing...
I have three rear sides. All would need some work but looks like good main glass
one is an early year without wing window
$50 for all. Pick up or shipping is likely expensive at your cost
come and get these from me
Thanks
Can the most forward pinion bearing be replaced without removing the entire third member from the diff? Or pulling the entire pinion?
yes I know the race may be bad too but just trying to get away easy for once
So... I gots a Leaking Rear output Shaft / along with some strange scraping...
Upon disassembly of the parking brake and speedo housing... there appears to be a THIN "O" SHIM there .
None of the tech / service books appear to have this in there... its like 1-2 MM +/- thick
Can anyone tell...