I'd like to add an oil cooler to a 2F. The factory setups seem to be uncommon and on the expensive side (compared to a cooler I already have) since the oil tap at the filter is pressurized. Am I looking in the wrong place (ebay)? Is there an easy way to tap into the unpressurized side of the...
What's the best air filter for a very dusty environment with very very fine dust? Playa dust, in case anyone's familiar with that. It's not very abrasive, and not that bad for the lungs, but is pretty much the finest naturally occurring substance I've ever run across.
I'm thinking about a two...
Hi all,
I've got a 2F forklift engine with an Impco CA125 propane carb on the forklift manifold - 70mm bolt spacing with a ~43mm hole. This is a bit bigger than the propane carb that came with the engine.
I need to add a second butterfly valve. Ideally it'd have the 70mm bolt spacing top and...
Hi all,
I'm back on a project trying to get a little more power out of a propane 2F engine used in a stationary application.
I need just a little bit more power at 2100 rpm. The engine won't be run over that.
It's currently got a hacked system on it - header, short pipe, random muffler.
Can...
Hi all, new user here, first 2F, first post...
I'm looking for some advice about a 2F forklift motor that's being used as a stationary power plant.
It's been converted to propane and appears to be lower on power than I'd expect, and I'm looking for advice. It's not a lot low on power, and I'm...