Search results for query: *

  • Users: DSjachna
  • Content: Threads
  • Order by date

Forum search Google search

  1. D

    Saginaw pump placement, 78 FJ40

    Anyone with similar setup? Would appreciate pictures. Trying to get belt alignment coming off rear grove of water pump pulley to rear grove of pump pulley dead nuts. Right now belt running slightly to the left of center on pump pulley, front of pump pulley assembly almost hits fan, return...
  2. D

    PS Pump Brkt.- Mark's Offroad vs. smog brkt.

    Have Sagniaw Pump mounted to smog brkt. on 78 FJ40. Question is, will Mark's Brkt. allow the pump to set-up higher than the original smog brkt.? With smog brkt., return fitting on pump angles very close to the driver's inside fender apron. When attached, return hose is wedged up against the...
  3. D

    VDO Ammeter

    Looking to install a stand alone VDO ammeter on steering column. As mention in related posts on the subject, have replaced OEM instrument cluster with Dolphin/Shark instruments thru BTB products, mainly because tired of not being able to see info. A night . Hope these new instruments solve...
  4. D

    Ammete

    Looking for input on the recommended aftermarketstandalone ammeter ana good mtg. Location. Want to connect to shunt.
  5. D

    Ammeter + Voltmeter

    Anybody installed both? Would like to see description & pictures of your setup.
  6. D

    Another 78 wiring question

    Can anyone explain why the two wires ( + and minus) going to the orginal ammeter are so large compared to the other instrument wiring? It's obvious my knowledge of electricity is very limited, unfortunately didn't take this into account when making the decision to remove original inst. cluster...
  7. D

    78 Wiring Question

    Installing Dolphin gauges and from old harness need three wires where only one is present. For example the RB, LB and WB wires going to old dash gauges, I now need three of each to power up the new gauges. On the net, have found some two into one wire connectors, no three into one, that I...
  8. D

    Solid Red Wire, to 78 Headlight & Dimmer Switch

    Need to understand relationship of this wire to dimmer switch. Following wiring diagram, this wire provides power to light switch on dash. Diagram also shows wire running to dimmer switch. My scenario of events, pulling light switch to second position lights up low beams, pulling turn signal...
  9. D

    VCV

    Ordered one of those expensive VCV for the left side of my 78 , applied vacuum and was encouraged that unit held vacuum but didn't open far enough to allow air flow. How many inches of vacuum need to be applied. Can they become plugged and therefore no air flow eventhough open? See on another...
  10. D

    So What's up with this

    Ordered new washer pump motor, new on right, old on left, but with new, no way to hook up washer tube to pump. Toyota Dealer doesn't even understand. Insight please, for 11/78FJ40.
  11. D

    Another "What's This"

    Poor pictures , but if I was to disconnect the vacuum hose to the Brake Booster , you would see what looks like a minature Sononran Cactus sticking up from the right corner of the intake manifold.
  12. D

    Charcoal Canister, 78 FJ40

    From what I've read here at IH8MUD, the canister is non-serviceable, but I keep looking at that star shaped nut on the very top with what appears to be a rubber seal under it and saying what would happen if I try to unscrew that fitting? Anybody attempted this, saw where one fellow simply cut...
  13. D

    78 Wiring Diagram-Turn Signal

    Looking at the 78 Wiring Diagram for the Turn signal/Hazard Waring switch, what do all the little symbols mean? For example, Within the Hazard Switch Block, the symbols, B1, B2, L2, L3, L6 & F. The same question for the symbols in the Signal & Flasher & Turn Signal Blocks.
  14. D

    Here is another 78 Firewall question

    Is this opening stock?
  15. D

    78 FJ40 Firewall Questions

    Need help identifying the following hole in my 78 Firewall. See attached picture, taken on the engine side of firewall, and notice the three bolt holes slightly to the left and a little below, is this entry point for speedometer cable?
  16. D

    Wanted  78 FJ40 Dash Knob for windshield Wiper, Fuse Panel Cover.

    Looking for Winshield Wiper Knob and Fuse Panel Cover for 78 FJ40.
  17. D

    Idiot Column

    Anyone wired one of these into a 78 wiring harness, I need help. Think I understand the ignition side, but would like to here your solution, as for the turn signals, haven't a clue.
  18. D

    78 Toyota Electrical Wiring Diagram

    Is it possible this diagram as published by Toyota, And copied by others, is incorrect? According to the diagram, as published by Toyota, when the ignition key is in the start position, the radio circuit is hot and in the acc position, the starter circuit is hot! compared to the 79 diagram, the...
  19. D

    Wanted  Bracket, lower, carb cooling fan, 78 FJ40, 11/78

    Need lower mounting bracket for carb cooling fan on 78 FJ40, build date 11/78. Bracket bolts to firewall lower driver side, protrudes out to bolt to lower flange on carb cooling fan.
  20. D

    Another, "What is this?"

    This belongs on my 78 FJ40, build date 11/78, but I don't have a clue where. Any clues?
Back
Top Bottom