Hey guys girls , need to know the part no for the conector to the solenoid on starter grey plastic surrounding females place conector . Thanx in advance
Motor is still in car , the plate between block and bell house is like spring steel . Two threaded bolts stick down from rear main seal at back in centre . If you push sump up there's 5mm difference between sump holes and thread . Think I'll loosen off bell housing only need 5mm to be able to do...
Hey guys and girls , I removed 1hz sump to fix strainer and can't get sump back on . The 2 bolts in main seal won't go into sump . The plate between motor and bell housing won't let sump push in . Any ideas gurus on how to get sump on
hey guys , does anyone have factory measurement for ignition pump timing ? im set at 1.06mm at moment but have cold knock on start up . It goes away after a minute or so but is present .Oil pressure is fine straight away but rattle still present . would advancing timing help at all ?? cheers...
Had my hzj75 for years always been very quiet . Did oil change last week new filter 15w40 oil now I have rattle on start up until pressure comes up 5 seconds what the ? Any help guys on where to look
Here's the thing was running 15w/40 in my landcruiser did oil change and had tick. Changed to 20w/60 got the clutch tick and rattle on start up. Went back to 15w/40 start up rattle gone now just have an intermitant tick . Me be thinking it's the piece of broken baker light off sump oil swi
Nice where did you get diff cover from want one for my hzj75 ute . I've done suspension , tie rods , tyres , pto winch , paint job , bullbar , tail shaft spider bearings
Tiny bit sluggish but would rather have that and motor protected instead of thinner oil and rattle til it circulates . You have sold me good stuff ! Bundy time !