Hey Mud
Looking for a visor/windsheild cap for a early/pre-65 corrugated hard top. Needs to fit on the type of windshield frame with the long rectangular vent under the glass.
Stay Rad
- TSH
Hello 40/55 Crew!
I've been on mud for a while but primarily in the 60 side of things with my '85. I'm new to 40's and i'm starting on a new project. This thing has sat in my stepfather's garage for 10 years, but now i've adopted it.
It's a '65 and the 33575 on the frame and firewall indicate...
Got a Pair of Bolt-On Sliders for a FJ60. These things are tough as nails and easy to take on and off. No rot - Minimal surface rust where dirt got flung up. Been stored in garage for years.
450 OBO
Pick up in Glendale 91025
FJ60 hood insulation in serviceable shape. Some holes and saggy towards front. See pic.
20 bucks and local meetup/pickup in 91205 - shipping this thing would be a PITA.
No clips included but those are still available from dealers or online sellers easily.
FJ60 Hood Insulation by tracksuit...
FJ60 hood insulation in serviceable shape. Some holes and saggy towards front. See pic.
20 bucks and local meetup/pickup in 91205 - shipping this thing would be a PITA.
No clips included but those are still available from dealers or online sellers easily.
FJ60 Hood Insulation by tracksuit...
Was out last weekend and on the trail. Drove approx.. 80 miles to the location without a problem. Once on the trail, any short but steep hill i'd get a stumble. As the day wore on, it would get worse and worse, with the truck stalling on any (even slight) uphill grade. It would be hard to...
Hello All -
I'm trying to go through the Emission Control Manual and checking everything out. I tested the Spark Control System at Step 4 - Check BVSV and VTV with Hot Engine.
My question is this - What amount of vacuum is considered "high"?
My gauge indicated about 3-4 in.Hg, and...
i used to have a stock 60, but then i started adding stuff.
sliders, front arb, winch, roof rack....all added up and now my get up and go got up and went.
the 33's i'm running were fine and i liked the rubber overdrive, but now i'm thinking of dropping in some 4.11's. i don't really care...
I'm stuck in my driveway.....but i'd rather it be at home than on the trail.
I can't get out of neutral. With clutch pedal to the floor, and trying to put it in any gear, the shifter will only enough to let me feel the gear spinning, but not fully mate.
It is most obvious when trying to...
Seems like no big deal, but my oil pressure guage always reads high.
Start it up and it pegs past the H and into the black, and only touches the top of the white when low a quart or more. Never changes due to temp, RPM, or anything else.
Swapped out another gauge, same reading.
It's...
Anybody got an extra VCV? Mine became brittle and the lowere nipple broke off....also i'm looking for the plate that mounts to the frame under the raditator....
I'm located in 91205
Thanks - TSH
Can someone tell me where (by location of the blades in the actual plug or switch) the wires plug into the back of the 62 power antenna dash switch?
I'm in process of putting a 62 power antenna setup in my 60. i've pulled the blade connectors out of the existing 60 plug, and rerouted them a...
Been getting lots of rain lately, and now my front right footwell carpets are soaked.
At first, a while back, i was thinking my heater core might be going, but it definitely isn't coolant.
Is there any danger in leaving my climate control in "VENT"? Are there drain holes or tubes in the...
I'm setting up a FJ62 power antenna in my 60, and the switches for a 62 and 60 are different. I've got the 62 switch, but it doesn't fit. Anybody want to trade switches or have one to sell?
Please let me know - TSH
Got a smittybuilt front bumper off a FJ60 - bolts right on to the existing bumper mounts.
The mounting tabs aren't perfectly straight, but it's in good shape and solid, and i've got a couple extra end caps. You'd need new hardware.
I'd prefer pickup in SoCal - 91205
50 bucks?
TSH