I am usually ok at finding things on mud but this time failed. This is not the window mechanism.
The front of the driver’s window follows a u-bend track as it goes down. This track looks to be connected at the bottom by two spot welds and by something at the top.
My track has become...
Installed red head steering gearbox. Amazing difference in driving. If your steering is loose just do this.
I first tried rebuilding my leaking one, just could not get it to tighten up. Was cool to see how these things work but never doing that again.
For the record, there are 44 ball bearings in the 80 series Land Cruiser steering gearbox. Don’t asking how much time I spent searching that. Finally got the idea to count the picture. (Hopefully the wording above turns up in people’s google searches).
Awesome write up , Thank you
I was on a road trip at the time so just bent the broken spring into a hook and put it back in place.
I did buy a package of random springs after this a Princess Auto, in Canada, but never when back to replace it. Not sure what the equivalent store in the US would be.
Same here. Almost never notice my pintle. Easy to attach and I know it is not coming off, even if I flip it (ask me how I know). I have backed it up over hills when turning and never think about it.
Also agree with don’t bother matching the tire. It is a waste. These tires don’t drive the...
Nice. So many questions. Do you have actuators in all four corners? Where did you source them? Waterproof IP65? As simple as wiring them all together in parallel?
Probably a stupid idea since I have not seen it yet, does anyone use a pneumatic cylinder and compressed air to lift and lower their RTT?
I have a CDN M101 and copying a bunch of you built a rack the keeps it in the down position when driving and lifts it to 6’ when camping. I currently...
Hey Mud. Need advice on oil seals and what I did wrong.
Pulled apart the wheel bearings to find the spring from the inner seal had failed and was dragged into the bearing. I only drove 3 blocks. The bearing races were well seated. Bearing is shot. Dug through garbage and confirmed the...
Hi. Replaced my rear bearings and now my right rear brake calliper is not centred. Rubs the disc on the outside.
The only thing I can think of is I did not seat the bearing raceway all the way. The inner one is not in far enough in so the shaft is sticking out 1/16” or less to far...
Fixed leak coming off the roof through rear hatch. Turns out top ridge above the seal was full of mud. Never thought of cleaning above the seal.
Take 5min next time you clean to run a rag over the top of the rear hatch seal. Save you some bleaching.
Found a Toyota winch and got it mechanically installed. Also came with Toyota winch controller in the bag!!!
Anyone know where I can get a user manual or wiring diagram? Replacement seals?
Also any good place to get acc or ignition power under the hood?
I just did this. Used:
4” pioneer TS-G1020s
6.5” pioneer TS-G1620F
the 4” fit perfectly into the plastic cups after I cut out the bottoms.
the 6.5” were just installed on top of door panel. No issue with spacing.
Did I diagnose this right?
Rear passenger side wheel hot and smells burning. Put in new brake pad not long ago. Car is hardly driven and not by me so this may date back to then. I pulled off the caliper. Pins are loose. Piston moves ok. There is rust stains on the ouside of piston under...