Lights are flashing. VCS engine and 4lo. Car runs fine. Never seen this. Thanks - Joe! ***it resolved itself for now - no more lights*** Must have reset the system as I had multiple trips today. :) Yay!
Hey, I posted this on the classifieds section as well. Went over some rocks yesterday and shredded my step on my passenger side, anyone have a connection to get the piece? The step and two bumpers and hardware...located just south of Denver. Thanks!
I have a 2009 200 LC. Went over a rock and sheared the step bar on the passenger side. The end cap is off and am looking for a replacement entire bar. Wife is not happy with my 4 wheeling skills. haha. Located in south Denver. Thanks, Joe
Please don’t bang me up if I didn’t post this in the proper place...I got banged up a bit over the Holidays... the 40 won’t start without adding gas to the carb its a 21100-61024 - the rubber boot is DERANGED and cracked. Is there a place to buy the rubber boot or assembly? Pic is attached (I...
Hi Everyone - I have a 2009 LC 200 and I am looking for a new set of rims to replace my stock. Reason being there are some stock TRD 4 runner rims available (with brand new tires on them) available for a great price. My question is the bolt pattern for my 200 is 140 and the bolt pattern for...
Wanted - FOB for 2009 LC. Don’t want to spend 300 for a key at the dealer. If anyone has one that will work, please let me know. My in-laws puppy ran off with it and I can’t find it....yikes! I did search the forum here for a bit and didn’t see anything...
opened the tailgate last night and noticed two lights that are not on. When opening the top of the tailgate I see two lights precariously places under the hitch. Are these lights or reflectors?
Any recommendations for sheet metal work (rear quarter panel and sill etc) for a FJ40 in the South Denver area? I apologize in advance if this is not the proper area to post. I am looking for a shop that will cut and replace the rust. Will have to wait for paint until I save up again...
Hey everyone - it's almost Friday!!
My cruiser will not start/turn over after it has been sitting overnight. No fuel is visible in the carb window after it has sat for approx 6 hours.
d
If I put gas in the carb, she fires right up and I am good to go (until she sits for 6 hours).
I...
I hate to ask but here goes...
78 FJ40 mostly stock
Draining the tcase and transmission today and the drain plug size has me a bit confused. Does anyone know the size of these drain plugs? I tried 22/24 mm and they were both too small. I need to buy some more tools obviously...
I did search...
Hi everyone - I checked this awesome forum for a couple of hours today but still need help. Learned a lot from pin head and fj40 Jim.
My 78fj40 with a 85fj60 2f has been hard to cold start recently. I noticed that a vacuum line from the carb is not connected to anything -my finger is pointing at...
Looking to make a set of replacement keys (78 fj40 main key and barn door). I live just south of Denver and would like to know if anyone could recommend a place that carries blanks. I checked the dealer at Go Toyota on Arapahoe and was out of luck. In fact they were kind enough to try cutting...
I recently rebuilt my carb and this wire separated from the nut. Any help would be appreciated. I am looking to replace. Thanks! Joe
From the bottom of the carb.