Does anyone have a bumper tow car hauler available to borrow or rent? I will be picking up a truck in stocton. Its under 6k lbs and the trailer needs to be at least 16 feet. If no one has one available, a lead on where to rent one would be great. A winch would be a bonus since the truck isnt...
Hi all. I need to get my engine out of my 94 fzj80 and could really use some help. I am pulling the entire unit including trans and xfer. I hope to get it done on Thursday or Friday evening. Its all prepared. Im in Petaluma on Pepper Rd. Beer and Pizza will be included. Thanks.
Hi all, I have been an 80 series guy for some time but at 290K my headgasked blew. I was considering getting a Tacoma while I figure out what to do with my 80. I do plan on searching but am now in a serious time crunch as the 80 was my DD and only vehicle.
I am looking at used with a v6 and...
Well, 290K and it finally happened. I pulled the spark plugs to do a compression check starting with #1. When I cranked it over, I heard a loud pop. When I went around to the front there was fluid everywhere. Im in the driveway but the fluid was on the floor of the garage and sprayed on the side...
Does anyone know of a spacer for the stock steering wheel? I added the seat extension and now the wheel is even further away. I must have long legs and short arms. I'd like to move it at least two to three inches closer to me.
I was getting ready to change my belts and saw this wire no longer terminated. I traced it back to the bottom of the coil. There are two that come out of here. The other is bolted to the frame. Im guessing it's supposed to go to the manifold somewhere since it was off recently to replace...
I drove to work yesterday and all was fine. I head out to lunch and as I leave the parking lot it starts running real rough and very low on power. It sounds and feels like I'm running on 4 or 5 cylinders. The o2 sensors (denso I believe) are 2 months old. I will look at the harness at the...
I'm looking for a set of 37 x r16 tires. I prefer mud but would probably entertain AT. My tires are tapped out. I have been unemployed for some time but recently got a job. Unfortunately I have a lot of bills to sort out and now have a bit of a commute. I just need a used set to get me by for a...
Hi all,
Id like to get your opinion on a 60 thats for sale. I have had a 40, a 55 and currently have an 80. I skipped over the 60 series. I would like to know what you guys think of this truck.
1984-Toyota-LANDCRUISER-FJ60
Im looking for my brother. He is looking for a nice "stockish"...
I have a new OEM windshield for sale. I do not want to ship but am willing to drive to meet in the SF Bay area. I am located in Novato, Ca. PM with your interest. $475
Thanks
2011 KTM 690 Enduro R
I have a 2011 KTM 690 Enduro R for sale. Only 4263 miles. It has been well taken care of but also used offroad. There are scratches (plastics) but there are also a lot of extras that make this great bike even greater.
Suspension done by Mach1 using Race Tech valving and...
Did you pull your dorkel off when having a new windshield installed? I have a major crack and was going to have safelite do it. It was on when I bought the truck but if it goes on, it must come off right? The manual also talkes about pulling the wipers and cowel, is this necessary? I am...
I need the thickness of the flange at the transfer case of the front driveshaft. I had a new shaft built but the flange is way too thick. It measures nearly .5 inch which means the studs are now too short and the nuts only bite half way. They even had my old shaft as a blueprint. They are...
I had a noise from my truck which sounded like a bearing so I started by touching everything to check for excess heat. When I touched the transfer case, I nearly burned my fingers. The oil is full and looks/smells fine but I couldn't get over how hot it was. I touched it after a few hours on the...