Selling an Eezi-Awn Globe Trotter tent. Just picked this up for my Horizon trailer and my wife vetoed it because it is smaller than the 3 series I previously had on it. It is hard to find trailer-specific RTTs these days. This is a great tent that solves the annex problem us trailer people...
Viair behind the panel. Running hose to the rear bumper. Have only tested in driveway but seems to work fine. Switch protected form dogs etc behind ashtray opening. Popped in a sub while I was at it. None of it is visible.
Seems like some times it’s fine and some times there are issues. I guess I’ll try it and if its an issue I’ll try the Capet approach. We’re you able to snake the wires under the carpet or did you have to remove the carpet?
Yes. Trying to avoid noise. those runs are also pretty stuffed with factory wires and aux power. I am in a 93. So headliner is a no go. I think I will try and run it under the carpet somewhere.
I have power running down both door channels and would like to avoid running my RCAs there. Is there an obvious alternative wire run from the dash to the cargo area subwoofer?
The terminology in the manual is a bit awkward— but it does say to supply the yellow (constant) lead with a 15 amp line Direct from battery. As far as a separate amp set up, I am experimenting with the built in for now. I have a feeling it will be great and I already have a ham radio under...
Sony documentation is terrible. Sonic electronics did a test of the previous/similar radio rated at 40rms per channel and it pulled 42. So I’m pretty convinced the current will be there. Running new wire will give me piece of mind and I‘m convinced ill be convinced it will make it sound better...
I saw that 10 amp rating as well. But the manual actually says to connect to the battery directly and use a 15amp fuse. It says current will actually exceed 15 amps at high volumes. There are some YouTube videos showing output tests on this unit and it makes a surprising amount if power, drawing...
Thanks. I don’t think I was clear enough in my description. I was not planning on splicing into the factory harness. I was trying to figure out where I should splice the 10awg from the battery into the generic radio harness. Sounds like the best approach is to tap Into the yellow and black...
I am replacing a failed Kenwood single din radio in my 93. The PO removed the factory amp next to the glove box but left the dash speakers connected. I have removed the rear sub and amp as well as dash speakers. I will only be using four door speakers powered by the HU and a powered sub in...
This is my daughter’s first real diy Project. It is not going to win any beauty awards but should be safe and very functional when done. We are using what we can find in the garage and a lot of creativity. it’s a crash course in 12V, pressure switches, relays, and a whole lot more.