I have a plastic Harbor Freight ammo box that I keep all my oil change tools in, for all three of our vehicles. At the end of change, I wrap the end of the tube in a paper towel and stick it in the box. It isn’t too dirty. I tried those plastic snap in tubes and I always had more oil on me...
I can’t answer the glass question, but I can answer the turn signal question, assuming the mirror assembly is similar to a 2016 Land Cruiser. The painted part of the mirror pops off along the black frame. There are 4 or 5 hooked tabs that snap in. Use a really thin trim tool of a putty...
There’s a couple of companies in Australia that make different versions of a cover for the seat delete. Specialist 3D Products is one that I have enquired about but haven’t pulled the trigger yet. Around $190- Australia $.
There’s a thread somewhere on Mud about this.
Here’s a link to their...
I’ve got the Victory 4x4 plates and they’re solid. They’re easy to align and screw down. I’m not really thrilled about the holes with no backing. Thanks @arock for the idea…
The annoying part of the install is disconnecting the little blue electrical connector. Disconnecting that connector...
Which pieces are you missing? I’m missing 3 on mine, the 2 against the rear roof rack feet and the one just in front of the middle support. They’re all three the same part number. 75555-60020...
They’re yours. Not crazy about shipping, but I can probably do it. I’m old-school. I don’t do PayPal or Venmo, but my son does I think. I’ll get with him when he gets in tomorrow from school and we’ll figure it out.
I recently moved on from my 100 Series and into a 200. I’ve got a few things I no longer have a need for and would like to pass along to someone local who could possibly use them.
Toyota fuel filter
Denso coil
Passenger Side glass headlight
Power antenna
Gray cargo area jack cover
Gray overhead...
I’m not a member of ONSC, but I’ve been lurking around here for a long time…. I live in the Raleigh area.
I recently moved on from my 100 Series and into a 200. I’ve got a few things I no longer have a need for and would like to pass along to someone local who could possibly use them.
Toyota...
Take a few minutes and check to see if you have the filter door. Just open the glovebox and drop it down. You'll see the small door behind the glovebox if it's there. My 1998 Land Cruiser isn't supposed to have the filters, but the door was there from the factory. All I had to do was buy the...
Not too difficult, the three screws holding it on were really tight on mine. Once they’re out, super simple.
And believe it or not, my local Toyota dealer had the part cheaper than I could find an off brand at NAPA.
Where I got mine:
https://parts.fredandersontoyota.com/
Nothing glamorous. I noticed a couple of weeks ago after I filled up the tank that the gas needle wasn’t moving off full. As any Land Cruiser owner knows, that ain’t right. A couple of day at full, it finally dropped some, but only after letting it sit at work or home for a while. Not while...
YES…. It’s mostly screws/clips and some double sided tape. Pretty simple to remove. Just take your time and investigate as you go. Use Goo Gone on the old double sided tape and the inevitable dirt you’ll find behind them. The little black rubber gasket will be gently stuck and once you...