1971 and older split hood with spear (Hood latches not included). Hood is in so-so shape, but is solid with little to no rust. Has seen the typical crease across top, but has been hammered out (not perfect...I’m no body man!). Also has stress cracks by each hood tie down. Also a dent on the...
Selling a flat FJ80 pitman arm and a heavy duty 1 1/4” DOM drag link/relay rod. Rod is tapped 23mm left hand thread on one end and 21mm right hand thread in the other end and is 32.5” long and includes lock nuts.
This set up is used for upgrading to FJ60 or FJ80 power steering. You’ll need a...
Bought this from Iron Pig Off-road for $87.10 new. Only used for mock up. Will fit FJ60 box, but allows you to use larger 80-series TRE. Selling due to upgrading to 105 series sector shaft which requires 105 Pitman arm. $50/shipped.
Probably a long shot, but I sent off a 80 box that I picked up here on mud and shipped it off to WTOR for a rebuild. They just informed me that the sector shaft is warped and I can either find another one or I can get a new box. Let me know what you have!
Thanks,
Justin
I’ve read several different things saying to not weld the borgeson steering U-joint to the steering column and others that say just weld it.
I’m using the 3/4” bore ujoint and it doesn’t come with a provision to pin it. I’ve also read just to weld slow and let cool and keep a wet cloth on the...
I’ll probably regret selling this, but have decided to go NV4500 instead of the H55f to run behind an LS3 so I won’t be needing this.
$450/shipped. Located in Fayetteville, AR
About to remove my mini truck power steering box in favor of an FJ80 box.
Question for the sages. Were all fenders created the same? Are there any drivers side fenders (non US) that lack the provision for the steering gear box like the like the passenger side?
If so, are they still available...
Started my power steering conversion going from mini truck to 80-series.
Picked up a heavy duty tie rod and drag link from IPOR and I feel like they may be a tad short.
I’m getting not quite an inch (7/8”) thread engagement into the tie rod.
If I back the lock nuts out I have over an 1...
I'm looking to install a FJ80 power steering box into my 40 and coming up short on which Borgeson u-joint I need to connect from the box to the collapsible shaft. I found this below for 60 series boxes and was wondering if anyone knew if they are the same spline size.
"The input shaft on a 60...
Selling a set of HFS shocks that are made for a 4” lift. Less than 200 miles on them, but scuffed up from rolling around on the garage floor. I upgraded to Bilsteins so no longer need these. $100/shipped. Located in Fayetteville, AR.