Search results for query: *

Forum search Google search

  1. Y

    Tighten Distributor?

    Ok, i realize this is a lame question. My distributor isn't tightened down. I thought the bolt to from the top down would do it, but that bolt already seems very tight. I found (by feel) another bolt underneath the distributor that kind runs horizontaly underneath it. I can't seem to get...
  2. Y

    '79 FJ40 Carb Suggestions

    The stock carb on my rig stopped flowing fuel. I was looking for the best ideas to repair it. Originally I thought I would just rebuild it, but it looks much more difficult than I would have thought. If rebuilding it is as hard as removing from the truck it should prove to be a nightmare...
  3. Y

    79 FJ40 Carb Removal Problem

    I belive I have everything disconnected to take the carb off. The carb rotates in each direction, and seem s loose. However there appears to be something in the center holding it. I do not see any external screws/bolts. Am I missing somthing or is it just stuck on a stubboran pin or something?
  4. Y

    Measured height with 2.5" lift

    My 3/79 is sadly in need of new springs. She is sitting on worn stock springs and 31" tires. Trying to convince the wife that we should put Smokey Mountain 2.5" springs on her. She doesn't want it lifted. I figure keeping 31" tires, with fresh springs she shouldn't be all that much taller...
  5. Y

    Gas Pedal Pad?

    Anyone know where to find one of these?
  6. Y

    Tranny/Transfer Case Skidplate

    The PO of my 79 removed the skidplate, and never reinstalled it. It looks to me like it bolts to the frame through some threaded holes? That sound right? Since he didn't provide the hardware to reassemble it, can someone tell me what size & lenght bolts required, also size of washers? The...
  7. Y

    5-Speed in an FJ-40

    I have a 3/79 FJ-40 with the 2F & 4Spd. I'm researching the feesability of converting to a 5-Speed tranny. I'd like to do it as painlessly as possible, and with the greatest cost savings. What trannys will work either with or without adapters. What doner trucks should I look for, and what...
  8. Y

    Engine Cooling Fan & Cooling System Questions

    I recently replaced the radiator, thermostat, and all hoses on my 79 FJ-40. The temp guage runs on the second tick mark and sometimes moves to strait up. If after it's warmed up good and I have to sit at a lite it can move up to almost the 3rd tick. Then immediatley goes back down. When I...
  9. Y

    Trailer Light Wireing

    I'm interested in setting my 03/79 FJ-40 set up to flat tow. I'd like to have a harness up front that I can connect to my Truck, so that the FJ-40's lights are ran by the dodge. Does anyone have a part number or source where I can get a T-Connector to tap into the FJ's wireing? I'm trying not to...
Back
Top Bottom