Hoping a Landcruiser friend is in the area that could grab a part I found on Craigslist and ship it to me. The guy listing it said he’s only doing a local sale. Unfortunately for me, I’m in Texas. It’s an old air cleaner for a corvette, and not super rare (they make reproduction pieces), but...
Hey there I’m looking for two pieces.
First, I need a rear bumpstop mount.
Second, I’m looking for the mount that is tack welded to the dash that secures the windshield. I am attaching two photos with both pieces circled in yellow. Shipping would be to Austin, Tx. Thanks!
Can anyone tell me the rear inner axle tube/housing diameter? I want to run a hone through it to clean away all of the rust. I’d measure it myself except I don’t have the ability at the moment. Thanks fellow mudders!
After spending countless hours trying to make off-the-shelf items work for the wiper linkage bushing, I decided to get with a good friend of mine and see if he could develop a more permanent solution. Here is what he came up with for me. A new bushing that snaps together. I put a dab of...
need a few pieces missing from my 1984 60. Rear grey liftgate handle, rear liftgate access cover screws, rear liftgate lock button guide. Also need a grey window crank and locking clip. Front headlight bezel mounting screws. Good condition grey driverseat seatbelt (floor/receiver side). Thanks
Did early 60's use a single stage paint or base coat clear coat? I have a 84 paint code 861 blue and am wondering if the paint is single or base/clear. I am considering a respray and understand the benefits of going base/clear, but I prefer original.
Just purchased a new 60 and am looking for the typical hard to find FJ60 parts.
Grey HVAC trim Bezel
Early Blue/Grey Driver side Seat bottom cover no tears.
Early Blue/Grey Passenger side seat cover.
Good condition OEM Carpet
Light Grey driverside seatbelt (female/floor side)
Thank you
Looking for a transfer case and transmission inner shifter boot in good condition. Would also take outer transfer boot as well. Also looking for mounting hardware for outer transmission shifter boot.( I have the rubber piece that's all)
Can someone snap a picture of their fuse panel and relay diagram from the owners manual? I need this for my swap into a 40. I have the fsm, but the colors don't seem to match everywhere so I'd like a second reference. Thanks in advance to whoever gets this for me.
I am swapping a 3fe into my 40 and decided to take a look at a main bearing. What am I looking for? Should these be replaced? Should I just seal it all up with new gaskets and run it? I dont have any compression numbers, but I do know the engine was over 200k. I am looking for any and all...
Am in the process of putting a 3fe in and after reading through a lot of threads I'm still confused about the vss. Is it or is it not necessary to have it hooked up and why? And if it is do I have to get an adapter or can I just hook it up directly to the back of the gauge cluster on my 40. I...
I searched and didn't see what I wanted so here's my answer to the factory stereo. It's a removable fiberglass molded box that mounts to the factory location. Best part is that I was able to fit a real sub behind the panel and not lose the pocket. As far as sound... I'll ask the neighbors.
I am looking for a good condition oem front bumper. I would like it complete with mounting hardware and end caps with little to no damage. Please pm let me what you have Im in Austin tx. Thanks.
I am wanting to convert my 75' fj40 to front disk and was wondering if anyone out there had an extra setup from a later fj40 or 60 they would be willing to part with.
Anyone know of a place where I can get a new windshield weather stripping and all in the austin area? I'm wanting to take my fj40 out for its first drive this weekend, but it needs glass. Thanks