I am needing the seat back for the middle bench seat for the 71-72 5 piece bench seat
or the whole 5 piece passenger side if you dont want to separate.
tsmith.eng@gmail.com shipped to 76457
I am needing an axle shaft for my rear long side. During a rebuild I found my bearing surface on my shaft to be in poor shape. Had to put it back together and run it with a new bearing but it will need to be fixed in the future.
Shipped to Tx 76457
Taylor Smith
tsmith.eng@gmail.com
I am needing the vent socket and vent"ball" to go into my FJ62 as mine is locked up and broken.
It is the one that is on the driver side and has the close function.
I am also needing a Rear drivers side mud flap as mine is MIA if you have the hardware with it that would be great.
Thanks...
I completed my 5.3 swap DBW and now can not find a good slick switch to use to wire my cruise.
Dash mount / column / steering wheel
What is everyone using?
And it starts,
I am a bit late starting a thread but wanted to document and share my learning as a possible collaboration of knowledge on my leaning. I bought this 62 with original paint No rust and run great but wanted a 5.3 from the start so being a engineer I over complicated things and did...
I am a month out from starting my 5.3 swap into my 88' 62 and I have started a spreadsheet with parts and costs. If anyone one out there has a similar list that I could reference and build off of that would be awesome. Any notes that someone has collected would be well used as well. When I...
I have had a 40 for a while and just recently picked up this 62, zero rust original paint. Has 250kmiles but just got a 5.3 sitting in the shop to go in.
Just finished the front bumper and will start on the back soon. Engine will be last because it runs like a top. PO said that the engine...
So I can not seem to get the right fluid level.
I have a A440 with 250k on it with a cooler and it shifts super smooth. But... The fluid level is super Weird at idol I can check the fluid after shifting thru the gears and it will be on the bottom of the dip stick. Too Low. I'll add a...
I just picked this 88 up in Houston and it is beautiful. Bought in Houston and had never left. Zero rust anywhere and not a scratch on any skid plate. There is not any dirt underneath in the places it never leaves.
I will be asking for some help here and there but glad to be in the 60...
I am looking to do a toy swap. Right now I have a 1954 Chevy 5 window that is on a 86 4x4 frame.
350 TBI 96K on engine
700R4 with 12K on rebuild
A/C Heat
Disk Brakes / upgraded door latches
All new gauges
Everything works even the check engine light... Located in Hico, Tx. A
This is my...
I have two 3.7 third members that I swapped out on my 40 for 4.10 now that I have a NV4500. They ran great for me. The flange will fit early and late driveshafts.
$75 plus shipping
But wait there is more, if you buy two the price is $150 plus shipping.
Great for the 3 &4 speed guys...
I just did a 4" lift with HFS and have a good set of stock springs that are free to a good home. If you need a spare or a SOA. They are off of a 74'.
Taylor