Park indicator light lasted 267k miles and 29 years 4 months of service. OEM parts were just that good! That is a 3 to 1 burn out ratio for Drive to Park indicator light.
Need Yo Opinion - NYO
Bull Bar is Bright Aluminum and Headlight Trim (I hate the damn things) are Chrome.
Do I powdercoat the Bull Bar Black and paint the chrome Black?
Powdercoat the Bull Bar Black and leave the plastic tacky chrome?
I wish there was a headlight option without the groove...
I will start by saying I have searched the 80 Tech Forum and read through five complete threads and partially through several other threads. All dealing primarily with a intermittent "No Start" issue which I do not have. Most deal with the Neutral Safety Switch (NSS) and or it's connector (p/n...
Maybe we need a 3D Printed Parts for 80s thread. A thread where every 3D printed part available is listed or ideas for new ones are shared.
The following are two ideas I have for 3D printed parts. Maybe Outsane or someone else could take these on.
1) Replacement caps for the headlight level...
I have read several threads as well as swapped on 80 series alternator previously. I am missing something as I read the alternator can be swapped without removing the battery, battery tray, oil filter and Power Steering Reservoir to Pump hose. The last swap I assisted on we pulled the fan...
Has anyone had to trouble shoot the front camera? My wife's is not working. She has the ARB Sahara with a relocate kit. I unpinned all the ARB plug and reinstalled the factory plug and plugged the camera back up and no change.
Is there a troubleshoot for the front camera anyone knows about?
2019 28,600 miles Wife was driving down i40 and lost forward gears. Coasted to a stop. Reverse works but a noted hard shift into Reverse is present. Fluid level has been checked at temp and is Full. No codes are present.
Anyone experienced this? I figure it has to be a computer or sensor...
2019 with almost 29k on it. Spring Break and all forward gears crapped. No warning lights on the dash. Reverse works fine and the engine runs fine. It will pull slightly when in drive on completely flat ground but not enough to drive it anywhere. We had a oncoming vehicle kick up some...
Has anyone put the GX headlights in a domestic market 200? The grill and upper chrome look the same. Headlights and lower chrome on the grill is different. It would get rid of the chrome wings that look so stupid dividing the domestic headlights. In the long run it will probably be a cool...
I finally got the chance to install my ARB Mid Height Drawer and fit kit I purchased early last year. In order to install the Mid Height Drawers with the Fit Kit a third Filler Panel/Bulkhead kit is required. ARB's information about this set up is lacking and I have to thank Mud Connection 4 x...
I am planning a head unit upgrade with screen and dual camera inputs. Rear will be a back up mirror image unit mounted on lift gate.
I need input on a front non back up camera with the strongest IR (7 to 10 minimum) out there. Ideally I would love a 3 to 4 power zoom IR for this but I...
Obviously not related, however, I have never had any EGR codes or trouble. I completed draining 5 quarts of tranny fluid, pulling the pan and changing the transmission filter yesterday only to have P0401 pop the CEL!o_O
Wix #58610 trans filter (do not use gasket)
5 1/2 qts Valvoline
Toyota...
I am needing at least two Oak colored 80 Series door speaker grills or a subwoofer grill. 95-97 year range would be ideal. I need them in good condition. Hopefully someone who went with the Polks has a few.
Please let me know what you have.
Thank you for viewing this.
I have a set of four (4) Spidertrax 1.5" wheel spacers with less than 10 mile son them up for sale for $170.00 Paypal or Cashier Check mailed to me. This includes ground shipping to contiguous United States. All four have all lug nuts. They were installed on my 80 driven home and removed...
Earlier this year I picked up "Beaulah" and have since changed a lot of hoses, fluids, filters, thermostats, radiator caps, etc. Most if not all of this was stock 20 year old equipment. The PO had effected the PHH bypass so that wasn't high on the list.
Today while changing the heater hoses...
I challenged myself to replacing heater hoses and heater valve on Beaulah today. I had previously sourced OEM hoses and Gates Green Stripe hose for the replacements.
Just so it seem as though I was roadside in a third world country I waited until weeks of wonderful sub 90 degree temps had...