awesome Kurt,
Wow, what customer service. I'm good to go then. Yes I ordered the Marlins. Now I can dream about wheelin and not re-doing this project.
Thanks guys
I sent Kurt an email to see if he sent me the stock inner axle seal along with the Marlin Crawler. The one I put in looked a lot like the one I took out with the metal ring(spring) and everything and it fit perfectly. That would be a bummer but I would prefer that than re-doing the entire...
well that wasn't the news I wanted to hear. I put seals in the axle. Seated them and everything. Are there two that go in each side? I am seriously refraining from using four letter words on this post right now.
Didn't know how to change a battery last year :) and now about to finish a rebuild on my front third, knuckles, and hubs. Never came across these in disassembly but these spacers(?) were in my rebuild from Kurt. I am not referring to the conical nut or snap ring. They are too small to fit on...
When rebuilding my front 3rd and knuckles I found that some PO work left my passenger hub in bad shape. I need to find at least one new hub though to get my rig back on the road.
Unless you see a problem with the hoses, the old ones should be fine. I just did the conversion to R134 when I replaced my compressor and dryer. I went with Rex and glad I did. He was very helpful when I had a few questions during installation. Since I had it apart, I flushed my hoses...
Thanks for the information. I will call Georg and the driveline supply in Hurst. I have a few other mud offers for used ones too. Hopefully I can get some of my driveline vibration fixed, new 3rd member will do the rest when I have the cash.
Thanks. I tried cruiser outfitters and they said they didn't have any. I contacted them first since I will be using them for a new 3rd member this Spring.
The yoke on my front FJ62 driveshaft is bent. I need to either find a good used one, have a local machine shop replace then balance my DS, or find a new one. Any suggestions from the local cruiseheads?
The yoke on my front DS is bent. Anyone know where I can find a used/new one or should I let local machine shop have a go and then spin and balance it afterwards?
Thanks
JScott
Even though Nick has already left, I will throw my .02 in. Hwy 491 isn't the best quality, being a reservation road. Certainly flat compared to some of the other options I have driven but constant up and down swells in the road. There are lots of pull offs if you need to sleep for a few...