I purchased a BeCool Aluminum radiator for my FJ-40 (Chevy 350 powered) over two years ago. I don't know if it was the same radiator you received or not. Mine actually was made for a 55-57 Chevy, so I had to make serious modifications to get it into my Cruiser. Nonetheless, it is the radiator...
I can't answer your question about how difficult it is to change out the output shaft in the SM-465, but I have a question for you on the same subject. How many splines on the output shaft do you need?  :Do you have the old output shaft? How many splines does it have? I have a SM-465 with...
You might consider the NP-435 granny low tranny. These came out in the 70's-80's Fords. They are a great transmission with a low gear somewhere around 6.7:1 ratio. They are a lot more plentiful than the T-18 or T-19. Should bolt right up to that Ford engine.
Good Luck...
Tazman
Hi Preacherman......
I did not get any E-Mail from you. Anyway, my distributor (pointless ignition system) has a terminal that is for an electronic tachometer. I have a tach, so I just tied the appropriate cruise control wire into the wire to my tach. The cruise control wires that would go...
I installed the Audiovox CCS-100 on my FJ-40 (Chevy 350 powered with SM-465) and it works fantastic. I drove it to Moab and back (round trip of 2000 miles) and it was a blessing. The good part was that I took the tach signal off of my distributor so I did not have to install any magnets to the...