I am lowering my truck and looking to go back to a non-cv style shaft. Has anyone gone to cv and have a factory shaft that they would get rid of for cheap?
currently have metal techs castor correction plates and am looking to possibly switch the the landtank ones. Mainly because of the tie rod interface with the control arms and the coil springs hitting the bump stop. On the wits end website it mentios on the discriptsion that those are better with...
Has anyone done the fan clutch mod to an eaton fan clutch and thought that the 20,000 was too thick. I did it and it seems that it is always pulling. So much so that it feels like I have a substantial loss of power. I borrowed a friends scan gauge and it never really even got to 200 degrees...
Is anyone running 325/80 R16's. Looking to go bigger without having to get new wheels. I kind of like the factory wheels and would like to get 37's. The only ones i can find though are Faulken and Cooper's.
I just finished putting in a new headliner in my 96 FZJ80 with the tan/oak interior. It seems to be a good bit tanner than the one that I took out. I got this one from the local pull-a-parts. I thought that there were only two colors for the 80's. Oak and grey. Am I wrong in thinking this...
I went to J springs and now I need to sell my Old Man Emu 863 Heavy rear springs. They have about 10,000 miles on the. And no rust other than where the springs contact the lower spring perch. Still have the stickers on them. $125.
After putting on my bumper last weekend, the back end seems a little low. Checking to see if anyone would want to trade the heavys for J's. I'll split shipping. I have about 10k on mine and no rust. Still has the stickers.
For all the people that moved their axle forward in the stock mount. What size drill bit did you use? It seems to be a none standard size like a 45/64 or something similar.
I know it has been gone over before, but there never seems to be a final answer. Can one replace the valve seals without removing the head on a 1fz? I know to use compressed air to keep the valves up. Or as some have said, put rope into the cylinder. The later sounds difficult as it would be...
Are there any 80's in the mobile/baldwin area that have a dc front shaft on them. If so, did it fix your vibration and may I slap it into mine and see if it fixes it?
Are there any 80's in the Mobile/ Baldwin county area that have a lift installed that I could take for a spin. I am about to pull the trigger on a lift and am having a hard time making a decision. I am looking at J's front and Heavies rear, just worried that it will lift it too much and be too...
Okay, two part question. It starts off with me going wheeling this past weekend, and getting stuck in the mud for about an hour with the passenger side about rocker deep and the driver side was 6-10 inches up the doors. After spending about 8 hours cleaning( I hate mud), removing wheels, front...