I recently had the pleasure (sarcasm) of replacing the clutch in my 67 FJ45 with a 2F, SM420, Orion. I didn't have a cherry picker, but I did have a solid floor jack and solid chunk of wood to carve a cradle out of. Upon situating the cradle and jack up tightly under the tranny / t-case, I...
I am moving and need to clear out some stuff. I have two gas tanks for a pre- 1970 FJ40/45. One of them has been modified to fit a cage post in behind the tank in a FJ45 and relined. Both are in good condition (no rust). I also have a spare tire carrier for a FJ45LPB. FREE to a fellow...
For someone that is restoring a FJ45, I have two rebuilt, great condition axles to take. Complete from hub to hub w/ good brakes and tie rod. After I bought my LC, I built up the drive train w/ later model axles and put these aside. They've been sitting on a rack for the past 4 years, and...
KEEP IT and modify it. That truck is bad ass. I have a beautifully built up FJ45 as well, and my wife and I we're just talking about the same situation. We have two young ones, and where are we going to put them?
I won't sell mine, so, I'll be modifuing mine too, in the future.
I fabbed in a aluminum fuel cell under the bed of my FJ45LPB where the spare tire carrier was. I purchased the fuel cell from Summit. They have tons of various sizes and dimensions available. The one I chose is 19 gallons, only 8 inches tall and fits perfectly between the frame rails. I...
Taurus Elec fan
I picked one up to install for the exact same reasons mentioned above. My set up does not have enough clearance to fit the fan in between the radiator and the waterpump. I have a 67FJ45 with a 2f in it. Has anyone installed the Taurus fan set up with a 2f? If so, are you...
I have a '67 FJ45LPB with a '75 Califoronia 2F in it. The OEM California emissions Aisin carb needs to be rebuilt. I would like to replace it possibly with an OEM carb specified for the 2F but with NO SMOG equipment on it, and nothing larger in physical size, due to brake booser clearance...
I have a 1967 FJ45 and want to test my water temp and oil pressure guges to make sure that they operating correctly. Does anyone know the operating ohm range of these two guages? The service manual does not give the specs.
Thanks,
widened oem's
If you want them back within a year, don't go with Stockton wheel. They take forever and lack customer service. Since your on the upper east coast, seach the bullitin. There was a guy that had them done years back locally to you. If you are willing to ship back and forth, PM...
I have a '67 with later model ('75) engine and drivetrain. It has the originl guage cluster in it. To match the guages with the late model sending units, should I put in a late model cluster, or will the original work?
Thank, Brad
How many ohm is the stock fuel sending unit on a early model FJ40? I have replaced the tank with a fuel cell and an aftermarket sending unit. Upon rehooking the wires up, the guage is pegging out, even on empty.
Thanks, Brad