Hello friends.
Just got my F-Sport this weekend and it's a dream come true. Does anyone have information on an FSM for the LX 600?
Thanks so much in advance
Rafi
Sunnyvale CA
Thank you Darb. Unfortunately, the oil leak is behind the oil pump cover, between the engine block and the timing chain cover. I replaced the oil pump cover o-ring, twice, to verify that the oil leak is not from the oil pump cover. Thanks again
Hi Darb, did you remove the head and oil pan to get the timing chain cover off? I have a small leak behind the oil pump cover and I also need to remove the timing chain cover. Thanks
Hello gentlemen,
One more recommendation based experience: replace the filter housing with aluminum housing.
https://www.rockauto.com/catalog/moreinfo.php?pk=2477922&cc=1444370
If the light is on with the transmission cold, than the problem is or with the sensor, or the electrical circuit. Check the wire leading to the sensor... good luck
Hello gentlemen,
I am looking to download the factory service manual for 200 series. All links in the forum are "non-working". Please let me know where I can download the FSM,
thank you so much in advance,
Rafi Litmanovitz
Ken is so amazing. He checked the 4Runner and said that nothing is wrong with the differential, and even let her borrow his temperature gun to check the wheel bearings. Tali arrived to LA this evening.
Thank you so so much Ken.
Hello gentlemen,
I need your advice please on a noisy rear differential on a 1999 4runner. My daughter drove her 4runner from LA to Phonix to do a film project, when the rig started to make noise. Pep Boys diagnosed it as noise from the rear differential and estimated the repair to be $2,000...
Hello gentlemen,
I need your advice please on a noisy rear differential on a 1999 4runner. My daughter drove her 4runner from LA to Phonix to do a film project, when the rig started to make noise. Pep Boys diagnosed it as noise from the rear differential and estimated the repair to be...
Wrench to remove front engine pulley
Gentlemen,
Please find drawing of a simple tool to hold the pulley in place, while loosening the 30mm bolt. I did most of the work from the top so I am not sure why most of the posts show the work being done from the bottom of the rig.
Remove the...
Most Sears hardware departments carry 2 1/8 (two and one/eight) inch sockets which is 54mm. These sockets are 3/4 inch drive so you might need an adapter from 1/2in drive to 3/4in drive if you don't have a 3/4 inch wrench.
I know I am new to this forum and I am not trying to be the “wise guy” but let me please explain how I did it. Also, the “free washer” is also good way.
I used a high accuracy torque wrench with 1-15Nm scale, spring scale and dial indicator. Goal is to have zero play at the bearing. I...