For Sale my 1991 Toyota Land Cruiser 70 Series , HZJ77, 4-door , 1HZ non-turbo Diesel , RHD , Solid front and rear axles, 24 Volt, Fully registered, road legal , insured, passing emissions. Automatic A440F transmission; , 160,000 km (99,420 miles) Asking Price $16,000 or best offer.
Brief known...
Hello ,
Looking for a driver side , upper , rear door hinge for a an early 90s 70- series land cruiser. My body style is the HZJ77 however these are same as other barn door style doors. Attached pic. Thank You
Hi Guys, I've been looking through the FAQ'a and other posts about 1HZ underpower issues but can't find an answer to my question, hoping you got some input or can share a link from this forum.
I recently bought a '91 HZJ77 with a non-turbo 1HZ and since I live at 8500' (~2600m) I need to...
2008 FJ Cruiser in Denver Colorado 4x4 w/ diff lock white on blue 174k miles, very nice condition, second owner , well maintained w/ synthetic oil every 4,500 miles and tranny flushes with Toyota fluids . Auto trans, cruise, cd, power windows, doors and mirrors , back up sensors , hitch.
$11,449...
One more try on this post , some input please.
I got an 88 , just dropped in a 3FE from an 89. Here is what I got:
- Good cranking.No backfire,quick and smooth.
-Spark at all 6.
- New coil, plugs , fuel filter, cap, rotor etc..
-Got injector pulse.
- I aligned rotor at #1 at TDC , according...
I just dropped an 89 3fe into my 88 cruiser. I had to modify the engine harness slightly since the injector harness is slightly different and I wasnt getting injector pulse. So now:
I got spark, got fuel ( 65 psi), got injector pulse, cranks well, timing is good, new wires, plugs, coil, fresh...
Hello,
I just dropped in a motor in my '88, old one threw a rod. The motor cranks fine, good fuel, spark , compression, timing, but NO injector pulse. I noticed the harness is missing a round plug in it's harness ( right by the diagnostic plug). The picture shows the plug on the old harness.I...
Just dropped in a motor into a 62 ( old one threw a rod) and it wont start. Good cranking, good fuel pressure, good spark( new coil) im not getting an injector pulse. I have not checked signal from the distributor yet . I did swap an ECU and a distributor from antother 62 - still the same...
My 88 FJ62 threw a rod, I bought a used motor from a good member on MUD , pulled the old motor, installed the new motor and the flywheel (flexplate) wont budge. It seems like some clearance issues or something. If i unbold the tranny a 1/4" away from the motor the flexplate turns fine. Any...
GREETINGS,
Has anyone took their fj off the frame yet? I am trying to come up with a creative way to do this in my garage ( with no lift i should add).
I m thinking of couple of engine hoists and a fabricated crossmember setup that will go between the frame and body to assist in lifting...
I will be removing my 62 off its frame later this summer and figured that would also be a good time for an undercoat treatment.
Any suggestions for products you have used and like? I plan to sandblast and treat all of the sheet metal and both of the axles. I m willing to spend the extra $ for...
Need a 3FE LONG OR SHORT BLOCK!!!
I m looking for a short or a long block for my 1988 fj 62. I would prefer a motor that ran before being pulled but will consider other offers.
Thank You
Dave
dbebak@Yahoo.com