looking for a set of 4 or 5 OEM 18" 100 series wheels with center caps. Would prefer local pickup anywhere between baton rouge, LA and Pensacola, FL. Up to Jackson, MS
BUT... willing to buy from ANYWHERE if the price and wheels are good.
thanks!
-Jeremy
Looking for a stock Toyota (OE) alternator for the 1FZ-FE engine as well as the lower timing chain cover for this engine, possibly the air intaker boot if the rubber is in good shape.
othere misc FZJ80 parts:
-windshield wiper switch assembly
I have searched for hours and cannot seem to find the answer, but if I've overlooked it, I apologize for the redudant post.
Any rate, here goes. I finally got a set of correct turn signals for my 75 (aftermarket, but original Yota ones comeing from a great fellow LC fanatic). THe previous...
Duh... :doh: I hate to say I wasn't thinking, but obviously wasn't. Will I be able to use the brake booster on the 75 or will I have to swap that out as well? I can easily get a setup off a 94 4 runner.
Hey gang,
My 75 FJ40 (built 5/75) has the infamous leak at the rear of the master cylinder and will not hold pressure (original unit and been sitting for 2 yrs with previous owner). I am having trouble findng a rebuild kit and even a place to get a mildly priced rebuilt unit from. I'd prefer to...
Bump to the top...
I have ran into a snag. Napa seems to be the only place to get the master cylinder rebuilt and they have the kits for my particular master cylinder on BACK ORDER for months. Other than paying $200+ (which I can't afford right now) from SOR or CCOT, it seems like I'm stuck...
Hi Cruiser heads, I'm looking for a brake master cylinder rebuild kit for my 1975 fj40 (makde 5/75). I know some say not to rebuild, but the cylinder is perfect inside. The seals/gaskets just rotted away from 35 years of being in fluid. Really, it's the last 2 years of sitting unused (previous...
Wanted to buy for my 75 fj40:
-upper and lower dash pads; must be good shape but not necessarily restoration perfect.
-front drive shaft; as long as the yokes and shaft are good, then I can replace u-joints & flanges.
-electrical harness, preferrably complete, but will take parts, depending...
PM sent.
Interested in:
-Front doors
-spare tire carrier, hinges, latch, etc...
-wiring harness for truck
-steering wheel
-hard top
-may want entire vehicle if price is right. Where in north Alabama?
Thanks!
-Jeremy
Are any of the following still available:
hard top parts (top, sides)
front doors
rear ambulance doors
axles (F&R)
leaf springs
rear heater, piping & fan switch
If so, please let me know and pictures as well.
Thanks a ton in advance!
-Jeremy