Hello everyone, been a while.
I’m looking into relocation both my start and house battery in my truck. Currently I have the two stock boxes in the front.
Reason for moving them is I have 6BT Cummins in mine as well as a ARB and M12000. The truck handles the weight fine but I’m wanting to move...
I am selling my ARB RTT & Baja rack combo. The rack is customised by Jason at Crusin off road to be low profile on the 80. The tent is a few years old, I have spent 5 nights in it in the 3 years I have owned it. The previous owner used it a fair amount. The tent is used and has a very small...
Hey guys, I have a right hand side battery box for sale. This is the one used on fzj80's for adding a second battery. I also have the slee washer relocation braket included.
Looking for $90 for the two.
OK so those of you do not know me from my past build thread in the diesel section I'm a diesel fan. I started my swap saga with a Isuzu 4bd1t mated to a A440. I rebuilt the 4BD1T from the ground up, everything was replaced or refurbished. Long story short a slight overlook on my part and having...
I have my old 1fz York 210 adapter braket and the York for sale. The adapter uses existing threaded bolt hols on the head and places the compressor above the A/C and thermostat housing. No other mods required to fit, runs on a longer A/C belt. Worked great airing up my 35's and brothers 37's...
I have the rad from my LX still available. Its new from Toyota just over 2.5years ago. Its the upgraded 3 core brass one from a 93-94 after 94 they went two core aluminum. Paid over $550 for it with my Toyota discount. The only down side is I had a fan blade give out about 4 months later. At the...
I guys looking for some help. Does anyone know if the BJ60 fan is in the middle of the rad? Meaning is the fan shroud in the center of the rad. I have an HJ60 one here and its offset to the passenger side. i need one in the middle if the BJ60 has that I would be looking to buy one.....Steve...
Am in the middle of my swap and have a question about the break lines that run forward past the steering box. One goes back to the rear and the other goes to the left front wheel. Both lines start at the ABS unit. My hope is I can get rid of those lines and use a new shorter line to the front...
I have a set of Gen1 MT/R's two are about 60-70% and two are good for spares or mock up. One of the better tires moving it around our place picked up a nail and needs a patch, centre of tread.
Looking to get $350 OBO Pick up in Langley.
I have a HJ60 rear SF axle with all new 1000kms on them rear brakes (Drums, shoes and hardware) the axle shafts are in great shape (no degradation where the wheel bearings run, bearings are 3 years old). This axle is also already set up for a spring over with springs pads welded and e brake...
Hi there,
Need to know if anyone has this data? I need to know on a 97 FZJ80 how many pulses pre revolution the stock speed sensor outputs (on the t case).
Thanks the help is much appreciated.
Parting out my 97 Lexus LX450, Up for grabs is:
The transmission (A343 280kms (170k miles)fresh trans fluid) - $350
Exhaust from engine back, cats are good and it passes air care (smog) new O2's 1.5 years ago. Muffler is a 2 year old Bosal (no whistle under hard throttle).
Stock intank fuel...
Parting out my 97 Lexus LX450, Up for grabs is:
The transmission (A343 280kms fresh trans fluid)
Exhaust from engine back, cats are 3 years old and it passes air care with ease. Muffler is a 2 year old Bosal (no whistle under hard throttle).
Stock intank fuel pump.
Also have an un cracked...
Looking to get a transmission brought the lower mainland. Anyone vacationing or coming over in the next few weeks with a bit of room. Weight is around 200-300lbs. Not in a rush to get it over but I cant get over to pick it up till September and would like it before that.
Willing to off set...
Looking to get a transmission brought the lower mainland. Anyone vacationing or coming over in the next few weeks with a bit of room. Weight is around 200-300lbs.
Not in a rush to get it over but I cant get over to pick it up till September and would like it before that.
Willing to off set...
My parents friend used this as emergency (power outages) back up for his Oxygen system. Unfortunately he passed away this spring and his Widow has no use for it. Was only used 3 times when the power went out I would say less than 15 hours run time. All manuals included. Has a few scuffs from...
Hello,
I'm in the process of building a diesel engine for my LX. I want to keep it all mechanical (no ECU's for EMP or zombie apocalips :P) https://forum.ih8mud.com/diesel-tech-24-volts-systems/702121-isuzu-4bd1t-lexus-lx450-land-cruiser-build.html
I'm going to be running a A440F out of a...
My Wife was at her North Van education center for a meeting last night and had a bad mechanical sound that turned out to be a dead distributor. So i gave her a ride home and left her with the Lexus while I headed to Vernon for work. Got a call this morning that her car had been stolen in the...
When does Mat (being our voted in adventure planer ;p) usually post details on the May long weekend trip? Trying to plan time off and schedules for this.