I pulled the p brake drum and found 2 of 4 bolts have been sheared off and a 3rd seems too long.
I have my brake kit, rear tcase seal AND speedo sleeve ready to go...
But it looks like i should be on the search for a new speedometer cable housing.
Advice?
Think Marlin crawler sells that...
Finally installed the cable and pedal to match the Weber carb.
Original carb and cleaner set up were long gone when i picked her up in 2009. Had a small Carter on there.
Throttle had to push/pull rods and linkages and so was a lot of slop in gas pedal. Enough to make it very difficult to...
https://chilechallenge.org/
Since I'm spending the winter down here, going to meet the nice folks with the LCFWDC. 😁👍 signed up to run and cleanup volunteer.
Gotta represent.
Hey All, could use some help and insight.
Wifes 4runner has started to sag almost a full inch on rear left drivers side.
I have a full eibach stage 1 installed 6/22 that felt and handled great all year.
Starting noticing the "sag" a few weeks ago.
Stock al wheels and brand new Falken...
I seem to get about 2 years out of these pricey mech pumps.
I think they can be rebuilt?? Anyone have kit info?
I am currently stuck in Springer NM and the pump went out on me.
I may have to rural engineer am elec pump inline?????
I searched the FAQs but couldn't find much. I know a lot of...
I got the axles apart.
Im no expert, but methinks this groove in both race and housing is the death knell for the CV or Birfield joint.
Any thoughts on replacing? 83 Fj60 parts going on a 74 fj40.
No hard wheeling but it will be off-road plenty.
Is this normal wear?
Thought these were catching...
It was either rebuild the whole drum set up or do swap...
Brake pedal has always been hard as a rock with merely a hint of deceleration which may indicate booster issues. Pretty sure that is original to the 74.
I have the longer braided lines to install as well that will give the lift room to...