New joints, still noise but now i found the culprit. The outer pinion bearing.
I got the race out too
I looked through the hole at the inside and the inner bearing looks good.
I'll replace that outer bearing and the oil seal and should be good.
Hi, I removed the rear driveshaft and drove in 4H. No moaning noise! So it could be the U-Joints moaning? I thought U-joints tipical noise was clunk or click . I think i order 2 U Joints and give it a try before i open the axle, what do you think?
Hello,
Since a few months i have a strange noise coming from the rear diff. The noise is there in low speed, no mater if i accelerate or not. It sounds like a bearing moan. I thought it was the rear wheel bearings. I replaced them and the noise is still there. Lo leaks, no play on the drive...
Hi Free, i know the post is old, but i need an info.
I too have bad brakes and the rear reservoir empty. Did the replacement of master cylinder resolve your problem?
Thanks
Gilles
Remove the busbar and check the plugs for continuity.
New glow plugs don't mean working plugs.
I had new plugs and after some months of smokey starts i checked them. One plug was burnt.
So i replaced it and i had nice starts without smoke.
Ok, i solved the problem for my smokey superglow bj42. :D
It was 1 burned glow plug! I never suspected the glow plugs because i recently replaced them by new ones. So even if you have recently replaced your glow plugs, check them with your multimeter!
Now i start my Toyo in cold temps within 3...
Wow ! Unbeleaveable! o_O
I never thought that bus bar could affect the superglow 3b cold starts.
I searched a long time for a solution for my rough smokey coldstarts.:bang:
I'll check it on my BJ42. I'll report.
Thanks
I don't think it's the transfer case, because it does the sound when i let it roll down with engine off and gears in neutral.
No roof rack, no aftermarket accessories, allmost stock.
Hello,
I have a strange noise while driving my bj42. It's a sort of light whistle noise (like air). I hear it well with window down. It begins at 40 km/h. It is less noticeable at faster speeds. It makes the sound even when it rolls down a hill with engine cut off. So it's not an engine issue...
Hello again,
I have rough starts lately with a bit white smoke for 10 seconds and a bit shaking (seems to run on 2 cyl for 10 sec.)
I measured voltage at the busbar. I have 24 V for 1/2 to 1 sec maximum! Then i have 12V for 17secs.
The 24V should be there for 3-4 seconds i think. Or is the...
Hello,
With my BJ42 i am driving sometimes in the mud. I lock the hubs and put the shifter in 4low. It drives good in mud, everything normal, but occasionally the car gets stuck because the front wheels don't turn, allthough i am in 4wd low. I know that the front wheels don't turn because...
Thanks for reply essar,
The valve cover gasket is dry, the oil is right under the water pump.
I think i'll retorque the head bolts, in the same time i can check valve adjustment.
Here's another pic
Hello,
My 3b (BJ42) has a small leak in front over the water pump. I cleaned several times to see where it leaks exactly. It's not a big leak, the front around the water pump is oil wet, the oil goes to the valve side cover. Tthere is never oil on the floor... but i want to know where it comes...