Search results for query: *

  • Users: petveedub
  • Content: Threads
  • Order by date

Forum search Google search

  1. petveedub

    Opinions please. Looking at a possible purchase. Undercarriage questions.

    We’ve been looking for a GX460 for my wife, and I’ve found one that checks all the right boxes (color, price, mileage, etc.) except living it’s first two years in Indiana. It's a 2012 with approximately 160,000 miles, regular approximate 10,000 mile oil changes according to myLexus service...
  2. petveedub

    AC pressures within range, but no bubbles after shutting off engine.

    All refrigerant was mysteriously gone after safelite replaced the windshield. No leaks, and no previous problems. I think an employee may have been upset that I required rivets, and wouldn’t let them use screws. I’ve tested and recharged the system (vacuum pump and gauges) Low side pressure is...
  3. petveedub

    Seat belt doesn’t lock at full extension

    I just had both front seat belts repaired by Safety Restore for my wife’s LX470. They had blown pre-tensioners. I’m in the middle of installing them and the passenger side works fine. The driver’s however will not lock at full extension. Can someone please verify if this is correct or not. I...
  4. petveedub

    Airbag light blinking two codes

    I have airbag codes 64 and 74 on my wife’s ‘01 LX. I haven’t touched anything electrical. She’s just been driving like normal. Is the sensor the most likely cause with both sides showing an error or is there a common connection/connector inline between the belts and sensor that could be the...
  5. petveedub

    Looking at a low mile 2017 in the salt belt

    I’ve been keeping my eye out for a 2016 -2017 Tundra like I would have ordered if I had been in the market back then. I missed a 2016 with 24000 miles in southern California a couple of weeks ago. Now I’ve located a 2017 in New York set up even closer to what I would have wanted, and it only...
  6. petveedub

    Second row legroom

    I asked this as an addition to another thread, but thought I should post separately to possibly get more input. I was reading a thread from 2012, and someone posted that the 60 and then current 4Runner were about the same size. I haven’t been in an earlier 4Runner, but I am familiar with the...
  7. petveedub

    Insight into an HJ61 for the long term

    It was suggested that I post this here as opposed the 60 series section: I’ve read all the threads I can find on HJ61 vs such and such, using as a daily driver, etc., but I would love more input. So I have a $25,000 to $30,000 budget, and I would go through Steve Jackson with Land Cruisers...
  8. petveedub

    A penny for your HJ61 insight.

    I’ve read all the threads I can find on HJ61 vs such and such, using as a daily driver, etc., but I would love more input. So I have a $25,000 to $30,000 budget, and I would go through Steve Jackson with Land Cruisers Direct. I really like the looks of the 60 series, and I prefer older...
  9. petveedub

    AC pulley bearing part number

    2001 LX 470 with rear AC. Does anyone know the bearing number and original manufacturer of the AC bearing? If not I will take the pulley off to find out, but I would like to risk breaking or distorting the clip only the once. Of course, a part number for the clip would be great too. MegaZip...
  10. petveedub

    I'm tracking a vibration issue and have a few questions

    2001 LX470 with 202000 miles. I've swapped the AHC out for stock Toyota, leaving the remaining AHC components in place. The upper and lower control arms, CVs, rack, tie rod ends, rotors, and sway bar bushings all have somewhere around 10,000 miles on them. The bearings should have about the...
  11. petveedub

    Oil filter cooler o-ring part number

    Does anyone happen to know the part number for the o-ring that seals between the oil filter flange and oil cooler at the oil filter? I have a small oil leak and have already replaced the the figure 8 o-ring between the oil filter flange and block. If the cooler o-ring doesn't stop the leak then...
  12. petveedub

    Droop and rake questions after swap to LC suspension

    I searched but couldn't find answers to my specific question. Last night I finished replacing my wife's 2001 LX470's AHC shocks, springs, and torsion bars with stock Land Cruiser parts. I set the droop at 2". I drove around the block a few times, and then parked it for the night. When I got a...
  13. petveedub

    AHC to land cruiser suspension?

    So, I've been reading through posts and can't find an answer to what I need to know. If someone knows the post I should be looking at feel free to point me in that direction and thank you. I want to go to oem land cruiser suspension on my wife's 2001 LX470. I'm pretty sure that would be the...
  14. petveedub

    Is this steering rack new or remanufactured?

    I just received an order from Olathe Toyota that included my rack, part number 44250-60050 at $545.54. The box has the correct part number on the sticker (no stickers on the part), but cast into the part in a couple of places is the number 60020. Their does seem to be a 44250-60020 rack, but I...
  15. petveedub

    Error code help please

    Hello all, My wife's 2001 lx470 sounds like it has an exhaust leak or vacuum leak. I can't find a leaky hose and it definitely has more of an exhaust smell than is typical in the engine bay. My neighbor is a retired master certified mechanic and he thinks probably exhaust but maybe intake. He...
  16. petveedub

    RTH: serpentine belt snapped...

    I will be doing more research, but any quick input would be appreciated. The serpentine belt snapped on my wife's '01 LX470 while she was dropping my daughter off at school. Other than telling me a few days ago that it "might" be a bit more sluggish than usual, their have been no other...
  17. petveedub

    Compression numbers...

    I'm going to be removing my injectors for cleaning as well as cleaning the rest of the fuel system since my LC hasn't been driven regularly of a little over two years. I say regularly in that it sat for two years after a birf threw a tantrum and destroyed the spindle and bearings or perhaps the...
  18. petveedub

    Rear axle click...

    I'm doing my first rear axle rebuild, and I may have a problem. As I turned the hub and axle on the passenger side (with rotor, caliper etc. removed) their was a steady click, click, click as it spun. With the axle removed their is no click, so definitely not the hub. I don't have the rear...
  19. petveedub

    Wheel damage from rotor

    After I busted a birf my rotor made contact with the wheel. What do you all think about using this rim? The damage is all the way around and dug in a bit as shown in the last pic. Thanks.
  20. petveedub

    Wanted  80 series drive flange

    I need the later thick drive flange for my 1996 80 series. I only need one. Thanks
Back
Top Bottom