Search results for query: *

  • Users: vxlc80
  • Content: Threads
  • Order by date

Forum search Google search

  1. V

    Wanted  93 80 series parts

    hi im looking for driver and passenger side ac vents grey interior and front left and right door panel cloth and grey
  2. V

    Wanted  80 series window switch bezel

    i need 1 set of brown window switch bezel
  3. V

    Wanted  80 series window switch bezel

    Fj80 Power window switch bezel brown 1 set
  4. V

    3UZ transplant to 80

    has anybody done this?
  5. V

    Wanted  LX450 parts

    hi im looking for lx450 parts interior wood trim all 4 door trims and shifter console rear right quarter panel flare
  6. V

    Wanted  Land Cruiser 200 series cross bar

    looking for 200 series factory cross bar
  7. V

    TJM vs OME

    Whats your input with these springs OME721 and TJM 770rr82a im looking for a near stock height with bigger payload. TJM mentioned 100 kgs constant load and OME up to 200 kgs.
  8. V

    radflo vs king coil over

    any comparison between the two pros and con? planning to upgrade
  9. V

    cross bars

    hi any idea where can i get a oem cross bar for 200 series or from any other toyota models that will fit?
  10. V

    climate control

    my climate control is delayed in starting and it doesn't store the last temp used it seem like it will reset or no stored memory every time i switch off the engine but if i switch off then switch on immediately it will still have the last setting any idea what is wrong?
  11. V

    Wanted  200 series cross bar

    im looking for 200 series oem cross bar
  12. V

    stock rake height

    hi any idea what is the stock rake height of the usdm land cruisers? i have a GCC spec LC200 it sits almost level. i wanted to change the spring to ome720 -.75" or ome721 0" but this is based on usdm measurement am right? i want to retain the GCC spec height but with more load capacity need you...
  13. V

    2uz ecu pinout

    hi does anyone have the ecu pinout for 2uzfe with a442f tranny? i waan do the manual torque converter lock:)
  14. V

    a750f conversion

    anybody done this conversion with success i have a 98 lc100 with 2uz non vvti and a442f trans middle east spec i was planning to convert tha transmission to 5 speed
  15. V

    a750f conversion

    anybody done this conversion with success i have a 98 lc100 with 2uz non vvti and a442f trans middle east spec i was planning to convert tha transmission to 5 speed
  16. V

    poor returnability

    hi still got the same old problem with my steering with poor return to center wheels alligned, tire pressure is ok, atf is fine, ball joint tie rod are good no leaks on the steering rack. any inputs?
  17. V

    tranny check

    hi i have been trying ti figure this one for a long time first start in the morning when engine and tranny temp is low i fell like the transmission is more responsive crisp and aggressive a few minuets after when operating temp is reached it becomes less responsive and less crisp didn't notice...
  18. V

    torque converter manual lock

    anybody done this mod?
  19. V

    A343 to A750 conversion

    anybody done the a750f conversion? im want to change my transmission to 5 speed:D
  20. V

    Dashboard removal

    anyone tried to pull out the dashboard pad or shell? i wanted to find the rattle and check on for lose/missing screws
Back
Top Bottom