Cranked up the truck this morning. My lady said I was leaking something. Come to find out it’s fuel!!!
I cannot see where it’s coming from. But it’s so significant I cannot drive the vehicle.
If anyone has some suggestions or has experienced this please help!!!
Thx in advance
I have a couple of stripped holes on my right knuckle. I was going to bump the stud up a size, but the more I think about, I'd rather find another knuckle. Anyone know where I can source a used one??
Thx in advance.
I have some serious exhaust issues. I've welded up every leak I can, but I think it may just be time for something new.
Anyone have any thoughts or ideas on replacement?
I was thinking I could just build a jig of the entire exhaust system starting at the flanges before the cats and just fab...
Take off the crossmember. Get a drill press and a new bit and cutting oil. Drill it out on low speed Be sure to clamp the crossmember to the press for safety.
Tap properly. You're good to go.
In the paint world, the base coat (color) is typically only applied to cover. The clear coat is the thicker of the layers. It's what has the UV protectant in it. So...colors aren't going to be 7 costs thick.
Anything metallic will cost more to repair as far as materials and labor goes.
I am in the maritime fabrication and paint industry in charleston, and have done a bunch of body work and painting using the toyota whites which do fade and lose luster after a while. But if they are taken care of...
Sounds like it will need to be trued as well. I recently discovered my rear drive shaft has some gnarly runout from wheeling. I'm taking mine to the driveline shop to be straightened, balanced, and new joints put in. Frustrating sometimes, but I caused it...
I had the same problem w a wet headliner. Blew out my sunroof drain tubes and I'm good to go. I am in charleston sc. It was record breaking this weekend
My wheel has some gnarly shimmy, so I figured I would go ahead and replace the bearings. I had Glenn at LEXTECH do my front right bearings about 8 months ago. I just don't see how it's all that hard to do myself. I've purchased bearings, axle seals, and the appropriate "extra tools" needed such...