adding a turbo to 1HZ and plan a coolant temp sensor in this threaded hole in the water outlet housing (or drilled/tapped into the current plug that's there)... Is there an oem adapter that fits here on 1HDT? I can't seem to see anything on parts diagrams. Threads on plug appears to be M16x1.5...
Complete set of barn doors and license plate holder including hinges, latches, and light. Left door is probably beyond repair but right isn't horrible. Plate holder and is decent, Light has one stud snapped off short.
Asking $120 plus shipping from 50312 if you take all. Please PM
I have a 22 gallon Downey aux rear poly tank like in this old for sale thread, but in unused/undamaged condition
https://forum.ih8mud.com/threads/downey-fj40-22-gallon-fuel-tank.1210306/
Got this in a pile of parts and need space more than the possibility I'll get to putting it to use.
I've...
This came from a running 40 I parted several years ago - it appears to be the exact unit sold by Cruiser Corps here for $279.95 with the addition of sender
https://cruisercorps.com/collections/fuel/products/gas-tank
$160 plus shipping from 50312... please pm me
Anyone have a used turbo exhaust elbow from an FTE laying around(turns basically 90 deg to the rear and down)? I know I can buy new but hoping for cheaper/faster as used...
TIA
I'l be driving from Des Moines IA to Easton PA with an empty suburban around Dec 17 and happy to haul cruiser stuff along the route for a little extra gas $...
Doing post mortem on a 2F that died... think this is the culprit?
Two questions:
1) what would cause this to erode/burn away like this?
2) I notice the "49" marked on top of each piston is different than "46" which I find in another engine I opened up... does this indicate that the dead engine...
Can anyone clarify these specs from the 1HZ manual I have dowloaded? Why is it listing different ranges for "STD" vs "US 0.25 and 0.50"?
Is anything between 0.036-0.077mm acceptable??
Adding turbo to 1HZ... does anyone have experience using a sump return fitting like below vs welding in place? Is fast/easy worth the possibility of it leaking?
While I have tranny out thought I'd do easy seals and gaskets... local dealer parts guy said there are two p/n's for the oil seal in the fj60 tranny front/input bearing retainer, pre- and post- sometime in 1986.
What would be the difference? Might there also be a difference between h55 and h42...
At risk of being a stupid question, is it true that 1HZ engine rotational position does not matter when installing IP other than being at TDC so keyway aligns? It appears so from the manual but I'm trying to get my head around why it doesn't need to be at TDC #1 compression stroke (or otherwise...
In the process of pulling the IP from my 1hz to send off for rebuild I did an oops and would appreciate thoughts on whether it I could have caused any issues.
The oops was in removing the main nut off the IP shaft to release the IP timing belt gear before pushing the IP out rearward - I did...
Any thoughts/advice on using this newer/cannister style OEM filter setup from 70/200 series cruisers on a 1HZ/60 swap? I've been advised that it is less prone to leaking air in over time as well as the that the replacement filter media elements are smaller/lighter/cheaper, while overall being at...