http://denver.craigslist.org/cto/4742925432.html
85' fj60
Only rust is drivers side rear wheel well
2f with 170k miles
Desmog
Trollhole carb
Newer windshield
96 4Runner wiper arms
New water pump
New thermostat
New engine mount
New exhaust
New side cover gasket
New oilpan gasket
New valve cover...
I currently have 4.56 gears with 37's and an h42 trans. I want to get a lower crawl ratio and wondering if anyone could recommend one or the other. I'm not to concerned with top speed, I can do 70mph at 2900rpms.
Im going to be purchasing either the rubicon or sportsman and wondering if anyone has these in a 60.
Sportsman is recommended for Toyota and the seat back is a little lower and more upright
Rubicon is recommended for jeep and the seat back is taller and more reclined otherwise the seats are...
Every now and then, more often lately my 60 won't idle. I have a desmog and troll hole carb. It ran fine with no issues for almost a year and then it sat for about six months until I finished my SOA. I've changed plugs, cap and rotor, coil, plug wires, fuel filter and I've ran about 2 tanks of...
Another issue with the soa, I need to notch the cross member so the front drive shaft want contact it. Anyone have some suggestions I was thinking of just using some round stock that's like 5-6 inches and replacing a section with it.
Anybody ever purchased from Beijing Sunday campers? They look like quality tents and I think they make them for some US companies, the price is A LOT CHEAPER but I think you have to purchase 10.
Might be a good group buy opportunity.
I'm finishing my SOA and wondering how many 60's with SOA use an anti-wrap bar with stock 62 springs and a 2f. Is there enough torque with the 2f and enough flex in the springs (in good condition) to really need an anti-wrap bar. If you have some please post some pics thanks.
Can I see some pics of how some of you guys mounted your shock hoops, I'm a little concerned with the amount of room on the drivers side with the steering box. These are what I have...
I'm trying to finish up my soa and I'm using the dc joints of an early 60 and attaching them to the t-case end of my drive shafts, this should extend them enough for the soa, problem is they're a different pattern so I need the early flanges.
In Colorado would be great.
Thanks in advance
Well after a long time of gathering parts I finally started my soa project. First I removed all my OME springs and shocks and sold to a fellow mud member back in November and while my 60 was on jack stands the ground became saturated and before you know the frame was on the ground luckily with...
Looking for the front inner passenger side u-bolt for a 62 housing, I'm doing an SOA and I think I need a square unbolt for this application due to the housing shape. If anyone has a source or dimensions for the u-bolt it would be greatly appreciated.
Thanks.
So all the research I did pointed to 5.29 gears for my 60 with 2f and 37's but now I'm worried I went to low. The gears are yukon brand new in box with master install kits would like to trade for 4.88 of similar quality. Would consider sale. Located in denver,co.
SOLD