Got into a bit of a fender bender this last snow storm, I am in need of the part # for the mounting hardware for the Front turn signal assembly.
Any help would be greatly appreciated
So
I had cv joints replaced by a reliable shop in town
Got my Vehicle back drove for a day or two
Noticed a knock from the left drivers side
When accelerating while turning
No other time
Just when accelerating while turning left
Took the vehicle back 2 times
They took the axle back apart and...
Both are NIB never used and have been in the garage since purchase.
All mounting hardware is included
ARB was purchased for my 2005 100 series.
Asking
$1100 for the bumper
$500 for the winch
$1500 if you buy both
So, i called around the Northern Colorado area looking to get a quote on an install for my ARB front bumper and a smittybilt winch and am getting $1100-1400 for instal. I am short on time right now and wanting these installed, but will definitely wait to DIY it if this is the going rate. Does...
So, I just purchased my first 100 and I am currently making a list that falls within my budget.
My goal with the vehicle is to be able to do some exploring with friends and family and occasionally the solo excursion. protestion, recovery and communication are my priorities.
I have been...
Looking to purchase a 2005
With 178k
I have some questions about the under carriage
The carfax shows this vehicle was ouchased in CA and then lived in CO
It has great service records and maintenance history
Is this rust still manageable??
Selling a fully loaded 1999 4runner limited rear Elocker and front ARB locker.
here is a link to the CL add.
http://fortcollins.craigslist.org/cto/4464524490.html
IH8MUD sticker already installed....
asking $10500 OBO
!!!!SOLD!!!!!!!!
Selling my LC I bought this a couple years ago from Jim (SROR), I am getting ready to buy a house, and am going to school full time so we dont have the funds or the time to finish her up.
1984 FJ60
So i dont really have the time to do this myself and was quoted $350 by a local shop to replace it. Does this sound reasonable, or should I look around.
Wondering if someone in the NOCO area had a set of rollers I could borrow for emissions.
Just got back and they said my tires were too big. 33s or smaller. I have 15" rims fwiw.
Im going to pillage a 1986 60 at a yard. The parts are pretty in expensive. Im looking at picking up some parts to sell(I need to help off set the cost of body parts)
what are some parts that are in demand and I could turn over easy?
also other than birf, what parts should I get for trail spares??
looking at a used arb locker
"ARB Locker - Locking Differential
RD124 - Fits Toyota Land Cruiser ( Landcruiser ) FJ40 FJ45 FJ55 FJ60 FJ62 FJ80 FZJ80
For 9.5" ( 8.9" bolt circle ) Semi Float Diff - Will Also fit full float but has one less pinion gear that RD142
Carrier was install briefly -...
I took the drive shaft off to change the u joints, and noticed a bit pf play in the rear flange. I want to check the pinion nut, tighten it down and see if that solves the play problem. What size socket do I need for the pinion nut on the rear 3rd??
Thanks in advance.