Search results for query: *

Forum search Google search

  1. elprup87

    Exterior Door Cladding (Trim Panels) - Clip Part Number?

    I can't see, captain...
  2. elprup87

    replace quarter rear window moulding/trim/channel replacement?

    Has the fit been confirmed to work on 2003s as well?
  3. elprup87

    Exterior Door Cladding (Trim Panels) - Clip Part Number?

    I had to do the same thing. Be mindful that my research found that the quantity and item numbers are not the same from a 4Runner of the same year. I was recommended to use some double-sided tape as well as the clips to resecure the body cladding on. I didn't take notes so I cannot tell if my...
  4. elprup87

    Yet another tire question... winter rubber

    Falken's AT3W have the 3Peak designation if I recall. I can confirm that they work well, but only based on our Outback as I have not run them on the GX. I am thinking about it, though. Honestly, I also have been eyeing the Klevers and just stud them in the winter.
  5. elprup87

    What Did You Do With Your 120 Today?

    Yuck ^^^ Installed a bafx OBD reader and OBD fusion today. I couldn’t seem to find a thread solely on OBD fusion sensors etc for setup. Does one exist?
  6. elprup87

    Builds Homer's 2003 GX470 Build

    MBR don’t have much of a yellow problem, but one is pealing. I’m certain it’s the original and was shot with a gloss coat in the past. That same side also has less definition of a low beam pattern compared to the driver’s side. Was that the case with you HC? I wonder if redo you did this can...
  7. elprup87

    What Did You Do With Your 120 Today?

    There are so many rigs (commercial 18wheelers) that have accidents on that side of the pass. It seems that at least one each year runs off the cliff (no joke). Here is an article with a picture of one of them. Speed and brake failure possible factors in Wolf Creek Pass crash that killed truck...
  8. elprup87

    What Did You Do With Your 120 Today?

    Correct. That pass has a distinct curve to it, no doubt about that.
  9. elprup87

    LED DRL and Flasher Conversion - No Hyper Flash

    If you bent the same one as a the video, you should be fine. Technically speaking, it does matter as to which one to bend (or use).
  10. elprup87

    What Did You Do With Your 120 Today?

    Installed and ready to explore! Not at all a replacement for the whole GOM mod but works well.
  11. elprup87

    What Did You Do With Your 120 Today?

    Have the cup holder in the open position so the cover is vertical. With strong fingers, pull up on the cover, straight up, no screws to mess with. There are trim clips (like the wood trim sections) that hold it in place. At least this worked for me. I cannot take credit, there was a thread on it...
  12. elprup87

    Bilstein 6112 Dilemma on GX470...not as low cost as I thought

    If you want to match, ICONs work as you said. BP-51s are another option but not sure how you feel about them. Personally, depends on $$, but a LT new front end would be sweet!
  13. elprup87

    Way to prevent mud from packing under factory skid?

    Yes, it looks like you’re missing that piece. I have the ARB UVP and love it. However, I have an ARB bumper so I cannot confirm how well it works with others. Coastal Offroad, and a few others, are making plates that are one-piece to cover this same area and under the diff. Be mindful if you...
  14. elprup87

    What Did You Do With Your 120 Today?

    Front diff fill plug is 29 ft/lb and drain is 48 ft/lb (or so I thought). My case was the previous owner, or shop, messed it up bad. There is much documentation on the drain plug having issues. I really like the 14mm hex plug (toyota part 90341-24016) compared to the 10mm female design. I...
  15. elprup87

    What Did You Do With Your 120 Today?

    Regarding the brake adjust, this adjusted the tension. I access the tension nut (not sure of the true name) by pulling up on the cup holder and used a 12mm to tighten the nut. When you put the parking brake through its motions, you will see how everything moves and the nut will be obvious.
  16. elprup87

    What Did You Do With Your 120 Today?

    I don’t know when the fluids were last changed, but after a few years of ownership we finally changed out the fluid properly. I did fluid changeout when I changed out the CV axle, but this was a proper way and man it needed it!
  17. elprup87

    Builds Homer's 2003 GX470 Build

    FYI, amazon had a decent price for the 14mm hex drain plug (front) the other week. I ordered one and it was cheaper than LexusPartsNow with delivery.
  18. elprup87

    What Did You Do With Your 120 Today?

    Nice subtle light location! Adjusted E brake cable (via cupholder method). Replaced the front diff plug today. I had to get it out a fun way....
  19. elprup87

    Builds OKADVENTURES GX470 Build

    Liking the Wildpeaks on the GX? We have those on our subaru and they work quite well, but the vehicle is a different animal. I really want Klevers but may have to get 255/80s from Falken as I really want the 3Peak design for driving all around in Colorado winters on the highways.
  20. elprup87

    Driveshaft Clunk!

    Interesting about the rear control arms. I can't tell for certain where my clunk is from but it does seem to feel like the front. I have not replaced ball joints or rear control arms. I may look at the ball joints soon. Given that I have coils in the rear, any mention of airbags don't apply in...
Back
Top Bottom