Hi all,
Does anyone have the shim selection charts for the 1hz?? I have looked far and wide, but everyone i come across seems to be a bad scan in that is near impossible to read. If someone has these or a good scan of there manual, it would be appreciated,
Cheers
60s
I run 4 wheel disks, all sixty series calipers, knuckles, modded knuckles as rear brackets on FF housing, vented rotors, 78 master with residual valves removed and a proportioning valve for the rear. Serious braking power, you could say its over braked! but that's not a bad thing!
Hey mate, I would look at OME from ARB. There is some places like dobinsons, but haven't heard any reviews. I would stay away from EFS as they are too short for raised springs. I just installed OME 2.5 on my fj40, my shackle angles is vertical, so if they don't settle down, ill move the hangers...
OME FUN
Well now i have managed to search, on a different topic by the way, shackle angle. I have found the common problems with OME 2.5 springs. I got outside before and popped my old stock shackles on for only a minor improvement in angle, bugger all! So with the aim to keep the lift that the...
Yes well i did account for the castor angle with 3 degree shims, my original springs had, what looked like a 1 degree shim. I think that to save on not forking out more money on ome shackles or modifying the shock mounts. I will re drill and shorten my shackles that i have made. I put...
I need some advice on my suspension set up. This has probably been covered before, yet i couldnt find a solution. I purchased ome leafs and shocks, installed with my own 2.5inch extended shackles. Now i didnt realise the ome shock where not going to be long enough. My options as i see it.
1. Go...
Mate, that washer looks like it is the wrong way around, turn it round so that the nut is siting in the dish, same with the other side, that might be the problem!
Mate, that washer looks like it is the wrong way around, turn it round so that the nut is siting in the dish, same with the other site, that might be the problem!
Rare Spares
Yep rare spares site isnt great, better off giving them a call. Geez if your box is in that condition, I would consider recon if you are going to put a heap more power through it, or it will probably fail sooner than later. Easier done now too!
Quarter Glass Seal
Hey mate,
Have you tried Rare Spares for the quarter and door seals, i got mine from there, and your right they weren't that cheap, but the quality was excellent,
Looks like a great rig to start a project with, Good Luck!!!:clap: