Search results for query: *

Forum search Google search

  1. K

    Loose linkage? 4-wheel dr. shifter.

    My rig is a '65 fj40, with a 350, automatic trans. and a fj40 transfer case with lockers front and rear. My question is--? How do I get all the play out of the transfercase linkage , I have looked ther is no adjustment on any of the linkage rods. I tried taking some of the play out by inserting...
  2. K

    Bypassing heater all together??

    Cut hose intwo at the site of leak, insert a snug fitting bolt into each hose, screw on hose clamps and continue to cruise. Or better still insert a piece of copper tubing and clamp for a Kentucky permanent fix.
  3. K

    XFER OUPUT SHAFT LEAK

    The napa oil seal is#17754 manufactured by CR or Chicago Rawhide demensions are 45X62X8---It does fit--- but still just a single seal. Did you know that leather was the first bearing, used on wagon wheels so as not to wear out the axles? Greased with animal tallow. Sorry I'm cooked I'll shut up.
  4. K

    Will it fit?

    Thanks Woody $200 would be better than on the side of road with hot engine. I"ll do some checking around and see whats up with the recore job. Later KyH
  5. K

    Will it fit?

    How much did the recore cost and did a local rad. shop do it?
  6. K

    Will it fit?

    Will a stock radiator from a 1970fj40 exchange and fit in a 1965fj40? I need a new rad. and rad.com only goes back to 1970 model. Thanks Ky-Hoosier
  7. K

    XFER OUPUT SHAFT LEAK

    I tried the speedi sleeve approach to no avail. Waste of about$40, not to mention the time and frustration. Went to napa bought a single seal $3.50. The only thing I did different was use the old seal to drive the new seal all the way to bottom of housing putting the rubber part of the seal in a...
Back
Top Bottom