Search results for query: *

  • Users: rfwj
  • Content: Threads
  • Order by date

Forum search Google search

  1. R

    oil pressure gage low but mechanical test gage reads OK

    I have an 85 fj 60 with a 2f engine from a 75 fj 40. Runs well, but recently changed valve cover gasket, oil pan gasket, and side crank case gasket. Now the oil pressure gage reads low. I put a oil pressure tester on it. ran at 10lbs at idle and went up 10 lbs every 1000 rpm. so i think i...
  2. R

    should i change oil pump?

    I am replacing the oil pan gasket and was wondering if i should change out the oil pump. i do have really low oil pressure at 700 rpm. it does increase with a rev of the engine. like all these 2 f engines. will a new pump help at low idle? thanks
  3. R

    new fuji carb help

    I just put a city racer fuji carb in. I think the idle solenoid is not working no clicking. fuel in site glass fine at 50%. How should i hook it up. Black wire to solo black wire. green wire to solo black wire. how should i check power to it? any help on initial screw settings would be...
  4. R

    carb help question

    Help. I have had this nice trolhole carb on an 85 fj for years and all the sudden not gas in the site glass. I turn the key and idle shut off clicks. Is there a way to get gas into the carb. I replaced the fuel pump and filter. so gas is getting there. thanks It will run sometimes then just...
  5. R

    VC removed. Do you have to have a CLD switch to make things work correctly?

    1997 LC. VC removed. If you remove the VC, do you have to have a CDL switch to lock the CDL to make the rear wheels drive shaft lock in high? why would only the front wheels work after a VC removal? Why would the rear wheels not work if the VC was removed? no CLD switch thanks
  6. R

    Power steering pump noise

    I have a 85 60 with a noise coming from the PS pump. clicking with the rpm of engine almost sounds like something hitting the fan but it is coming from the PS pump. faster when i rev. So my questions is: Is it the pulley bearing or the pump? Pump works fine. What is a good replacement...
  7. R

    Help with Highway Noise (linkage, CLD, Heat shield?)

    I have a 97 which has the weird noise coming from firewall area, I guess? I will post the noise below. Here are the facts: It never happen except when I am at highway speed 55 plus and it only occurs after running at those speed for about 15 minutes. It just comes on like a wind issue? If I...
  8. R

    Wanted  Looking for 2l non turbo engine

    Sometimes the JDM engine dealers have them but not any more. PM if you know or a source or have a working one. thanks rich
  9. R

    97 power steer pump bleed foaming

    I could use some help. I replaced my ps pump and did not bleed it correctly. lots of noise shining but it worked. So I did the lift and turn and it spit some liquid. I know I did not read and I thought the air would just work its way out. Anyway, it is now foaming and spitting. plus not...
  10. R

    Wanted  need a part help identifying

    This part on my 2l-2 is leaking. can someone help me identify or have one on an old injections system. I see 23811-54150 on the diagrams but it does not have three pipes as show in this picture.
  11. R

    quick question on alternator vs battery

    It seems my accessory drain my volt meter on my dash when the car is running. When I have wipers lights and radio on the volt meter drops below 12 on the dash. With all that stuff off, it peaks up to 14 to 15. Anyway, the alternator charges the battery and the battery runs all that stuff as...
  12. R

    fuel pump 2l-2 wiring and solenoid leak

    I could use some help with the wiring on a 1993 2l-2 fuel pump. I basically had a leak from where the fuel solenoid screws in on the pump. Serious leak. So I order a new solenoid. I put the new one in with the inner and outer O ring. It did not work as no fuel was getting through the pump...
  13. R

    fuel SOLENOID old one leaked new one does not start

    I put a new fuel solenoid on my pump. one from a part dealer in spain. Anyway it matches but does not appear to work. I guess i was wondering if there is a 12 volt and 24 volt one. I did not specify but I have a 12 volt system. thanks rich...
  14. R

    fuel solenoid toyota diesel 2l-2 engine parts

    My Mechanic says my fuel pump is leaking fuel from the fuel solenoid on a mechanical fuell pump 2l-2. I think 1997. replacement engine so I am not totally sure on the year, but i think that is correct. He replaced the O ring but still fule leaking. Any advice to get this little part or...
  15. R

    binding CDL stuck?

    I have a 97 fj 80. Binds when turning like the CLD locked. The light is not on though. It is still like something is locked. stops when completely turned right or left. I could use either some links or help testing and how to disengage the CDL. I have read there are relays and connection...
  16. R

    Wanted  where to buy new injectors for 2l-te densco

    if there a place in the us that sells injectors. the densco based on what i read. thanks rich
  17. R

    Wanted  power steering pump 1997 fj 80 needed

    Does anybody have a working, no leaks, power steering pump. I am in Charlotte/ fort mill sc. thanks rich
  18. R

    86 LJ 70 no turbo with 2l-2t with no computer question

    I have an 86 LJ that needs an engine or rebuild. Anyway, there is a great deal on a 2l-2te in the classified. The seller notes that the Computer is missing. Can you make this motor work without the computer with the old wiring from the 86 LJ 2l non turbo? thanks rich
  19. R

    Wanted  Looking for a 2 l engine for 86 lj 70.

    My engine has a scored cylinder. Could rebuild but would love to source a used 2l diesel. Even an older one to match my 86 Thanks.
  20. R

    glow plug help

    Long story and i cant get my glow plugs to stay on long enough. 1) replaced a blown 2l engine with a 97 2l two engine. 2) the old glow plugs from the 1986 LJ are in the 97 engine as they were working better with my old wiring. 3) It seems the are engaging but not for long enough. I am not...
Back
Top Bottom