Search results for query: *

Forum search Google search

  1. mountainman

    '74 Build: Dirtbike250x's Project: "Rotten Orange"

    You're bringing an old mountain truck back to life!;)
  2. mountainman

    '74 Build: Dirtbike250x's Project: "Rotten Orange"

    Beautiful job!!
  3. mountainman

    Gauges no worky

    I had the same thing happen last week. On my '74, the 5th fuse down in the fuse block controls the gauges(20 amp). I replaced the fuse and it still didn't work. I had to clean the fuse block twice before everything started working again.
  4. mountainman

    Timing gear noise

    Waterpump appears to be ok. It sounds fine when I use the stethoscope. Same with the clutch and throw out. Thanks for all the help! I'm just going to run it and wait and see.
  5. mountainman

    Timing gear noise

    I'll check that this morning. Thank you!
  6. mountainman

    Timing gear noise

    I just changed the oil and still have the filter,so I'll check it. The oil itself is clean and no metal that I can see. Thanks for the info!
  7. mountainman

    Timing gear noise

    Thanks Big B! I think I'll just keep running it until winter. That looks like it's going to be a pain to fix!
  8. mountainman

    Timing gear noise

    I've been hearing a squealing noise coming from the timing gear area. It's not all the time. First I took both belts off and still had the noise. I put new belts on and no change. I tried the stethoscope and narrowed it down to the timing gear area. I've read other posts and it could be the cam...
  9. mountainman

    Need help obtaining title

    X2 on Broadwaytitle.com. I'm also in Pa. and bought a 1970 Bronco with no title. They sent me a legal title that I took to a notary in Pa. and had it transfered to a Pa. title. Very easy.
  10. mountainman

    Quick gr starter question

    I just replaced my starter yesterday in a '75. It's just like Mr. Toads. I just put a piece of tape over the third wire.
  11. mountainman

    Steel fuel pump lines

    I got the used hard lines from the pump to the carb for $15.00 from Cruiserparts.net.They had the fittings and were in good shape.
  12. mountainman

    More trans/transfer case questions

    Thanks Steve!
  13. mountainman

    More trans/transfer case questions

    My transmission keeps jumping out of low gear and the transfer case whines in 3rd and 4th gear.I picked up a rebuild kit from Kurt for the transfer case,and picked up another transmission.It looks easier to pull both trans and transfer case at the same time rather than break them down.Am I...
  14. mountainman

    understanding fuel tank venting, fumes

    I went to Napa.They measured my old cap,then found a vented one that would fit. Mine is a '74,and they sold me a Napa Balkamp cap # 703-1034.Fits fine on the 40,and no more gas smell.
  15. mountainman

    XM Radio Antenna Placement

    I have mine mounted inside the cab,on top of the rollbar.The signal goes right though the fiberglass top.
  16. mountainman

    Driveshafts - Install Question

    FSM shows closer to the transfer case.
  17. mountainman

    Anyone have a Garmin Nuvi?

    Ed, The GPS Store, Inc. Garmin, Magellan, TomTom Systems and Accessories. I got a Nuvi 350 from them. Great little unit and easy to use. There's a lot of good info on the site.
  18. mountainman

    Leaking exhaust gasket help

    I only used one tube.I didn't go crazy and make it too thick. Just enough to get a good seal.I let the truck sit for 24 hours before starting it up.
  19. mountainman

    Leaking exhaust gasket help

    Correct. That's what I ended up doing. I had no leaks after getting the manifold nuts all tightened up.
  20. mountainman

    Leaking exhaust gasket help

    I put mine between the gaskets and between the block and manifolds. No leaks at all.
Back
Top Bottom