Copyright notice was an web builder default... fixed that... Didn't see that until now.
Again, I haven't copyrighted it and don't plan to or don't claim to have came up with the term.
Trademark is only for commerce use which I believe I was the first to offer it for sale... That's all.
Folks...
Not claiming I was the one to coin it originally, all the TM language and process is focused on first used in commerce, not general language. Not that I have a staff of lawyers to defend it, but it was approved through after a lengthy discovery process by the trademark office and it was...
Finally updated the pesky heater hose kit site and went through the trouble to trade mark pesky heater hose.
New site is www.phhkit.com
Also upgraded the hose kits to Samco's new extreme silicone hose. Hard to image they could make a better hose, but they did.
Enjoy and send feedback and...
Used or good deal on new. Have the rack, just need the tent. ARB Simpson or equivalent for 2 adults or 1 adult and 2 kids.
Let me know what you have or if you know a local Houston outfitter that you have done business with.
Thanks!
Did this the same time I did my PS hoses and pump... no more hissing.
Also will be selling the 2 lines for replacement on my site soon. PM me if you want them before I get the site re-done... getting close.
Lines are cut to length, top quality Gates... with or without SS Breeze 300 series...
Thanks for the interest everyone... kits are coming together this weekend and shipping out.
Some folks have inquired about the PS pump shaft bearing... unfortunately it is also not offered by Toyota at all, so I will be offering them.
I took a while and found the exact bearing that met or...
The three Gates power steering hoses and breeze stainless steel clamps combined will be cheaper than the 1 larger Toyota OEM hose list price (that you can order).
I tried the OEM clamps but the Gates Power Steering hose has a slightly smaller OD so they don't really clamp that well, so the...
Looking to pull the trigger on the Simpson III roof top tent and Kaymar Rear Bumper to bring my build to an end...
Let me know what you have and where you are...
Thx.
-Brett
So after pulling the blue e-tape off that was still left, the wires were still spliced, just the butts were left which should be under the blue tape of everyone's harness. Sourcing some correct lugs to run the positive cable from the alternator to the fuseable link. Everything should be in...
A helpful hint that I read around here for putting bearings on a shaft without a press... Freeze the shaft in dry ice in your freezer (1-2 hrs) and bake the bearings at 225 degrees in your oven for 30 min.
Slid right on. This was after I ruined a bearing trying to get it on with a...
Ok... I think I have this figured out, but any help or comments are appreciated... next on my list to get is the factory wiring diagram...
While I was rebuilding my steering pump and replacing hoses, I decided to 1)Finish up my wiring for dual bats, 2)Upgrade my worn out battery cables with...
Too bad you don't have your rig in Dallas... you could drive down on a weekend... Ive done several at this point... still don't look forward to them, but have it down pretty good.:beer:
Just did this per the Awesome write-up in FAQ ... https://forum.ih8mud.com/ca-jefferson-state-cruisers/467550-fj80-lx450-ps-pump-rebuild.html
Followed it and Dan's write-up on removal and went smooth once I removed Battery, Tray and Oil filter... doing some other electrical work so had planned...
Awesome write-up...
Decided to tackle this as its the last thing leaking from my truck... thought it was the seals in my pump, but after pulling it and the lines, realized my lines were hard as a rock and leaking as well... they were so hard in fact I could break them apart.
I ordered the...
Price Lowered... $2950 Shipped domestic US
Selling my unused NIB Toyota TRD 4.5L Supercharger for '95-'97 80 Series
Opened the boxes only to check that all parts were there.
-Brett