Hi Everyone
I just bought this on
Here is the link
It’s an exact match to the one in my 97 LC
The part number is I received it and it’s a Bosch with the number 44610-60792. Same as Toyota part number and a match in every way, even the bendix stamp except for the check valve which is a...
Hello All,
I got distracted and forgot to lock the rear diff. Anyways I realized this when I pulled the driver side rear axle out. Both tires were in the ground when I did this, passenger axle was still bolted in place at the time.
I had to use two bolts to get the axle out from the hub...
thanks Rex
If all is clean from the compressor and drier should I change the expansion block or leave it alone. My compressor is still good but the fan clutch is going bad. So I stopped using it to avoid further damage.
Inner and outer bearing
Romer,
Thanks very helpful for a newbie such as I. You mentioned cleaning the inner and outer bearing, why do we clean these are new bearing not included in Cruiser Dans kit?
thanks
Sorry for being such a newbie on this issue
Question -
1. Do I need the Slee harness for the depot lights?
2. will they fit in a 1997 LX450 without modification?
3. With Gary's adapters do I need to change or add any relays?
thanks so much
my compressor shuts off during the summer every time I hit 218 degrees, I am wondering if this may be due to the fan clutch as the temp will go up to 228 when there is pressure on the engine such as going uphill.
I have a hunter green lx450 with 108k miles. Absolutely no rust and in great condition. Everything works perfect. Any offer welcome. Looking for about $12,000 obo. no lockers
See pics at www.photobucket.com/ramien
PM me or call 714-475-8025
I have a hunter green lx450 with 108k miles. Absolutely no rust and in great condition. Everything works perfect. Any offer welcome. Looking for about $12,000 obo
PM me or call 714-475-8025
Right but....
I am doing the full flush today, So I did not drain the entire system when changing the hose due to time constraints. I needed enough to get me to the other side of the parking lot where I can flush...But yes you would do 2 and 2 for a full flush.
Hello all,
After reading the posts for over a year, I finally got around to doing my PHH.
It took me about 2 hours. 45 minutes taking tire off, jack stand placment and studying the set up. Another 15 minutes contimplating whether i should do it or not. I run a hotel and I am living in a...
Do you guys put exaclty 4 qts back in when refilling or do you put a little less than 4 qts ,drive around fro 20 minutes and check the level then fill accordingly?