actually im in the st.louis area and which splines are you referring too? i thought the disk brakes were the fine spline and the course splines were for drum.
hey all im in the process of building a 74 fj40. I have swapped in a front axle out of a 78 with disk brakes but my pops stole the axles out of it cause he snapped both of his while i was away at school. so if you have any front axles for fairly cheap lemme know i need both sides, inner and...
i am in the extremely slow process of soaing my 74 fj40. i was in the garage this weekend and i noticed that you can take the third member out flip the housing 180' and put the third member back in and it will bolt up the same way as if you had welded on new perches. i know there are a few...
im looking for a 74ish fj40 tub it doenst have to be in perfect condtion as long as the door frames and where the hard top sits is in decent shape im located in indianapolis but the cruiser i need it for is in ofallon mo so lemme know if you got anything close to either area
thanks
david
jeep for cruiser? (dont laugh)
ok heres the deal. i know this is a long shot but i figured id try. i have an 89 jeep cherokee with the 4.0 with 160,000 miles on it. ive always been a huge cruiser fan and have a 74 fj 40 that im trying to build up. thats gonna have to wait because im goin to...
fan and hazard switch and shackle pins
i need a blower fan switch and a hazard light switch for a 74 fj40 and i also need a set of shackle pins(stationary side of spring) for the same vehicle i have 5/8 i.d. bushings they can be used im just looking for somethin cheap but still good lemme know...
does anyone have any cage plans that they would be willing to let me use r know where i can get some id like to build one but not real good on makin plans
thanks
david
so what your saying is that the stock caster is 1 degree back from vertical(i dont know the "termanology") and you rotated your 3 degrees bakwardfrom that? ???
ok lets say that i bolt the axle under the spring with the new perches just like it would be if sprung over. After i set the pinion pointing at the t-case flange, i cut the knuckles loose. then i turn the knuckles back towards the rear. how many degrees past 90 do i go?? ???