Looks pretty good.
Oil leak looks to be primarily from the valve cover gasket but would expect to go through others seals as well as PM.
The interior looks great for age and miles.
Not sure if you are referring to center diff lock or factory lockers. Not sure if 94 had factory center diff...
They were Amazon knockoffs. They started shaking within a couple of months, not as bad as the stock units were but annoying enough. The housings started corroding after a couple of years. The drivers side adjust eventually stopped working which was what triggered me to upgrade. Come to find...
I ordered these through ClearviewUSA. There are no trim options. I assume you were looking at their Aus home site which does list all the trim options. Hope that helps.
https://www.clearviewmirrorsusa.com/#
These are the same company. Sooty mki had the original large mirrors and I think Sooty mkii may be running the nextgen mirror whic sits size wise between the compacts and the originals.
Ha! wasn’t expecting the looks to be so uh.. controversial. I’m digging ‘em.
@thatcabledude they are LHD but they use convex mirrors on both sides so both sides are stamped.
@OffRoadScott these are the standard 80 mirrors in the compact design. They have the power glass control like stock...
I have gone through the fixes for the shaky mirrors on the stock units and have purchased aftermarket replacements and haven't been happy with them. I have been looking at the Clearview mirrors but the standard towing mirrors were too big in my opinion. ClearView recently launched the Compact...
Have the bowfin and love it. I wanted to use the FR surf rack. The FR bars are roughly three inch bars with a center slot. To make it work I added a couple of three inch 80/20 bars which have the slot in the middle. Worked a great for the FR surf rack and I expect that it would work for many...
To the comments about paint earlier in the thread. My powder coater failed miserably on the color match so I ended up going rattle can over the new powder coat. The rustoleum engine enamel in aluminum was a good match. In the pic below the supercharger is original paint and the plenum and...
Might be over complicating this a bit. I just did mine a couple of months ago. I followed this thread from darkness to take the harness apart, splice two wires. All very clean, provides tons of length and is very easy to do...
Just installed my super charger a few months ago. Run the orange fan clutch from Landtank with the stock fan. No spacers needed, no issues from the start. Runs smooth, cooling is perfect.