Search results for query: *

Forum search Google search

  1. C

    Carburetor problems

    I have a fairlly new to me '82 FJ60. The engine runs very well but I recently installed a pto throttle cable. I had accidently left off a vacuum hose on the passenger side and was trying to find the reason that it was wanting to idle at 1000 rpm so I was looking at the carburetor adjustments in...
  2. C

    Camber adj. offset knuckle/kingpin cap bearings

    Dave: It doesn't do bad... the steering is pretty light and quick from the lower caster angle and not so stable as it might be... but surprisingly not too bad. With the caster angle off it doesn't snap back to center after turning a corner either. It sort of tentatively meanders a bit towards...
  3. C

    Camber adj. offset knuckle/kingpin cap bearings

    Pinhead... its not off by .5 its off by 2.5 degrees. It is currently -1.5 it should be +1.0. That is a lot and it will funnel the tires. The tolerance is .8 so if it really was only off by .5 it would b3e in tolerance. I think I forgot to put the actual camber reading in my post. Thanks for...
  4. C

    Camber adj. offset knuckle/kingpin cap bearings

    I have an 82 FJ 60 with all new suspension, steering etc. The caster is -.2. I am putting in 2 degree caser shims to take care of caster and make it a bit better tracking on the highway. I have about 3" of lift between springs and OME anti-inversion shackles which are about 1 cm longer than...
  5. C

    RUST!!!

    I assume most of you have dealt with some degree of rust and can help. First of all I have spent a lot on this 60 and it is a great vehicle... so now I begin to worry about that rust. the side where the rear window washer resevoir hangs had a leaky resevoir that the PO continued to fill it so it...
  6. C

    Alignment and steering questions

    Hey guys! I am new here and was told this is the place to ask all those tough questions. I recently bought an '82 FJ 60. The suspension was shot and steering was really loose. First I put a tie rod and relay rod end kit in it. Then I put tires on it and had it aligned, the caster and camber were...
Back
Top Bottom