Hi
The metal frame that surrounds the glass has rusted in the front, causing it to not wanna open.
Everything else is fine. Not sure if anyone would have just that part.
Thanks all
snaps
Hello,
getting ready to blow up my dash to dig out the heater core. Its a RHD, hj61. Now I have a ready to go heater from a LHD, 60. Are these parts compatible, or am I in for some more grief( doing this job is grief enough!)
Thanks so much!
Hey
I was changing the oil in the 5 speed and found this stuck to the drain plug. Not too
Versed on the innards of it, but have a sinking feeling that that’s not good. The trans is only 4 years old. Still shifts ok, a little Grind at times going to third and reverse. Should I prepare for an...
Hello! Yea I chickened out on this miserable job for now. Its leaking pretty bad. what Im wondering, should I flush it out with a garden hose to get all the coolant out of the core so it doesnt end up on the carpet, or does the leak make that a bad idea? Thanks
Hello, got a sinking feeling that Im way not qualified for this install! Was wondering a couple things: will a 1986 HJ60 heater core work on an 88 HJ61? Can these things be repaired at a old timey Rad shop if not? Thanks all
Hi All,
About to attempt the gasket swap. Anything I should watch out for? Never done before, looks like the turbo has to be disassembled? Or can I slide it out from under? Some said use sealant, some not.
Thanks for all help,
Snaps
hey all,
got a OME medium 2.5 suspension on an 86 HJ60, an I want to put it on a 88 HJ61. Dont have any part numbers, an a guys telling me theres 8 different bushings that it could be for this, does anyone know the exact one I need?
Thanks!
Snaps
Hi, just got a brand new 5 speed, and looking for a way to make the clutch easier to depress. Not even sure if these came stock in the 61s or not
Thanks
Snaps
Hello,
I noticed this while changing the oil. Seems to be about an 1/8th of an inch hole in the flat metal plate where the filter seals on. Noticed there was more oil in the filter and sprayed around than usual, but the overall amount wasnt terribly low. Sorry for the lousy pic. Big...
Hey all,
Gotta leaky rain gutter in dire need of attention. Trouble is Im short on time, a garage, warm weather, dry weather. what would you use to seal it for a month or so, then scrape it out an do it rite?
silicone maybe? thanks
Hello, after reading a thread about this trailer wiring kit for Tacoma's working on a 60 if you change a couple wires, I picked one up. My truck is a rite-hand drive 61, and what Im wondering, will the side marked "driver" go on the rite side taillight, or are all the 60's light wiring the same...
Hello all, just read a thread about how you can modify the hopkins tacoma triailer kit to work on a fj60. Has anyone done this on an HJ61 rite-hand? I was mainly wondering if the side marked "driver" would now go on the rite taillight, or is the wiring the same on left and rite hand 60's?
much...
And my windows down! Hey guys my widow lock switch on
The 61 broke off rite before the
Ice storm here in NC . This ever
Happen to anyone? The switch
And a metal contact fell out,
But it's stuck in lock. Is there a way to bypass it ? Thanks for all help I've included a pic of the
Piece that...
Hi all,
Can anyone recommend a trans gauge for a a440f/ 12 ht? Just
Went through a whole rebuild
and would like to not do that again for a while..
Also , what do you need to do/buy apart from the gauge, wires an sensor to make it work?
Thanks in advance Snaps
on my 12ht 61. This is probably a dumb question, but will the input and out put shafts work from
the fj62 a440s that toyota sells? also, any cooler recomendations? this is not a fun way to spend dough
on a cruiser($ouch$!!)
Thanks, Joey
According to guys at the trans shop. Its only at around 50mph then tapers off when i go faster.
Thought it was the TC. its been doing it for a couple thousand miles now(12ht/a440f). I checked the fluid
and it looked good and was full. I have to make a 300 mile trip for work monday and dont...
Hi it just happens to be what I got at the moment. Gonna take her a few hundred miles south
next week. Was wondering what the hiway ride will be like, thanks
Dropped the pan in the a440 to clean filter and
change oil- should of been
simple, but color me stupid, I pulled apart the
valve cover in right of pic
thinking it lead to the screen. After everything's
Back together, I'm pouring
the old ATF in another container and find a steel
Ball bearing...