Search results for query: *

Forum search Google search

  1. 2001LC

    Rust check

    Is this a joke, illustrating what not to buy! :cautious:
  2. 2001LC

    Acceleration vibration, CV? HELP!

    Wheel and tire balance, condition, PSI, etc.. is where we first look. Then bearing and FDS next.
  3. 2001LC

    Acceleration vibration, CV? HELP!

    Rust and crud build on wheel hub face and back of wheel. They need cleaning off (de-glazing) so surface matt flush. Also surface need to be flat. This wheel seem torque on. But as lip/raise from beating on wheel hub, ate into wheel. Since wheel wasn't flush when lugs torqued to 97ft-lbf. It...
  4. 2001LC

    LX470 AHC issues - pressure sensor 1998 Vs. 2002

    So It's very likely your shock had/have air in them, when you installed. This may be why you ran reservoir down from full. Air may trap in inner cambers of shocks. Detail matters! I was hoping for step by step detail, from you. As so often people say they did this or that in very general terms...
  5. 2001LC

    Leaking radiator

    What design flaw ?
  6. 2001LC

    LX470 AHC issues - pressure sensor 1998 Vs. 2002

    I have had DTC C1762, that was related to undercarriage wire harness. I posted some of the work here. Which, also had DTC C1736 accumulator. It turned out to be corrosion inside a rear wire harness housing connector block. Which was changing the resistance, depend on moisture contend. Which was...
  7. 2001LC

    VVTi Cam Seal Leak -- Cam Phaser O-ring?

    Glade it was sorted out.
  8. 2001LC

    Acceleration vibration, CV? HELP!

    If 50 MPH vibration wasn't there, before FDS (AKA Front drive shaft, AKA CV) service. Then it is service related. But often after a service, people are paying more attention. I'd first consider tire balance. Which one must also consider the back surface of the wheel and face of wheel hub it...
  9. 2001LC

    I know a lot of '06-'07 owners bypass the SAI system when it starts to go bad, I'm going to try to fix it.

    When replacing the BK 1 & BK 2 switches. The capture nut/threads, are in switches. So you can just bust the heads/bolts. Get new bolts to go with new gaskets and switches. You may be able to clear codes, just before getting to test location. Don't turn engine off, while/if in line waiting. You...
  10. 2001LC

    LX470 AHC issues - pressure sensor 1998 Vs. 2002

    I agree with Andy (@suprarx7nut) advice. Look elsewhere! You replaced the pump "due to some failure". What failure? Have you read pressures. What were the FL, FR , Rear and Accumulator pressures/Mpa?, when working? Would you have a screen short of AHC data stream? Both Andy and I, have both...
  11. 2001LC

    Brakes ...... Overdue write-up.

    VVVVVV I agree. I've never seen anything to indicate pedal stock is measured. Likely "fluid" a Toyota web page error. Toyota web page info and P/N, well. Suck! But by using VIN #, you're assured of correct part. I like www.partsouq.com for accuracy. It about as good as it gets, other than...
  12. 2001LC

    AHC Fluid Problem

    That's one service manager, I'd avoid. Where I have read in mud, of a Dealership buying a pump assembly due to bad fluid. I've never heard Toyota/Lexus corp., even hint at bad fluid or a recall. If you can prove AHC working before, the AHC fluid from Toyota/Lexus Dealership plastic bottles...
  13. 2001LC

    Drain hole under windscreen moulding?? Or is water pooling somewhere?

    I remove side molding and fill holes with 3M windshield butyl, until ready to repair and install. If I've concerns of water entry or rust. Factory Installed are never have issues. The back or top ends of side molding. Sticking up or having a gap between them and Roof Rack Caps. Are due to...
  14. 2001LC

    Ignition Coil Spark Plug Question

    Toyota Denso or Denso, either are great. NGK are also good IFR6T11 (Old#: IFR6A11). The biggest concern, are they legit. Many bootlegs coming out of China, which are total junk. I found the Denso TT to be a good plug, wherein China can't bootleg the 0.4mm Twin Tip electrode. A good Denso, will...
  15. 2001LC

    LX470 AHC issues - pressure sensor 1998 Vs. 2002

    You wrote: "My question is this,., Assuming that the pump gears may have air trapped in them... How do I remove any air IN the pump gears ... crack open the outlet fitting and let it drip for a few seconds ??" Since the fluid came back/pushed into reservoir from system, as vehicle lowered...
  16. 2001LC

    Brakes ...... Overdue write-up.

    200LC made between 07.1999-08.2000, which is only years with type A wire housing connector. So must it be the correct master.
  17. 2001LC

    Suspension fluid best brand

    It was Kuni Lexus parts guy, that told me they had notice to filter. When I drilled down. It was an internal notice, from shop foreman. It did not come from Lexus or Toyota. I tried to return some open plastic bottles to Toyota. My parts guys, is manager of parts. He could not accept returns of...
  18. 2001LC

    LX470 AHC issues - pressure sensor 1998 Vs. 2002

    Your PS SW may or may not be bad, IDK! If I understand you correctly. You R&R the AHC PS SW with new OEM. So you had determined, the original had failed. Then NEW OEM PS SW, also went bad, after running a full reservoir dry. Not sure how you'd run a full reservoir dry. But I assume you meant...
  19. 2001LC

    Suspension fluid best brand

    Yes. I know a local Lexus shop was using, after straining. But I'd be hesitant to use of/if any jell found in strainer.
  20. 2001LC

    Brakes ...... Overdue write-up.

    To be clear: This was a new booster assy w/master (the whole brake master assy) from Toyota? P/N matched to your VIN #. Great you disconnect battery before R&R. Than there should not be any change/damage to circuitry, relays, ECU or fuses. Make sure all wire housing block connected securely...
Back
Top Bottom